Magnetic hardening of melt-spun nanocomposite Nd2Fe14B/Fe magnets
Authors:
- 15 April 1996
- journal article
- conference paper
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 79 (8) , 4827-4829
Abstract
Coercivity optimization studies were done on melt‐spun nanocomposite Nd4R2Fe87−xNbTxB6 (R=Nd,Y,Dy; T=Ag,Cu) isotropic ribbon samples. The maximum attainable coercivities, after adjusting the annealing time, were found to be very sensitive to the annealing temperatures. The optimum magnetic properties [HC=3.9 kOe, (BH)max=10 MGOe] were obtained by annealing at 750–775 °C for a few minutes. Optimization by flash annealing gave similar results. Microstructural studies show that the grain size is greater than the theoretically predicted grain size for optimum coupling between the hard and the soft phase. With the annealing conditions used, Nd4Dy2Fe87NbB6 samples gave moderate coercivities and in Nd4Y2Fe87NbB6 samples the coercivity was reduced more than the expected reduction in the anisotropy field due to the presence of Y.Keywords
This publication has 6 references indexed in Scilit:
- Intermediate phases formed during crystallization of Fe-rich NdFeB alloysJournal of Magnetism and Magnetic Materials, 1995
- Enhanced remanence in isotropic Fe-rich melt-spun Nd-Fe-B ribbonsJournal of Applied Physics, 1994
- Giant energy product in nanostructured two-phase magnetsPhysical Review B, 1993
- Exchange hardening in nano-structured two-phase permanent magnetsJournal of Magnetism and Magnetic Materials, 1993
- Role of the heating rate up to the annealing temperature on the hysteretic properties of hard magnetic materials prepared from amorphous precursorsJournal of Alloys and Compounds, 1993
- The exchange-spring magnet: a new material principle for permanent magnetsIEEE Transactions on Magnetics, 1991