Effect of pH regulation by sulfate-reducing bacteria on corrosion behaviour of duplex stainless steel 2205 in acidic artificial seawater
Open Access
- 13 January 2021
- journal article
- research article
- Published by The Royal Society in Royal Society Open Science
- Vol. 8 (1) , 200639
Abstract
Sulfate-reducing bacteria (SRB) can regulate environmental pH because of their metabolism. Because local acidification results in pitting corrosion, the potential capacity of pH regulation by SRB would have important consequences for electrochemical aspects of the bio-corrosion process. This study focused on identifying the effect of pH on the corrosion of duplex stainless steel 2205 in a nutrient-rich artificial seawater medium containing SRB species, Desulfovibrio vulgaris . Duplex stainless steel samples were exposed to the medium for 13 days at 37°C at pH ranging from 4.0 to 7.4. The open-circuit potential value, sulfide level, pH and number of bacteria in the medium were recorded daily. Electrochemical impedance spectroscopy (EIS) and potentiodynamic polarization were used to study the properties of the biofilms at the end of the experiments and the corrosion behaviour of the material. Inductively coupled plasma mass spectrometry was used to measure the concentration of cations Fe, Ni, Mo, Mn, Cr in the experimental solution after 13 days. Scanning electron microscopy and energy-dispersive X-ray spectroscopy (EDX) were used for surface analysis. The results showed the pH changed from acidic values set at the beginning of the experiment to approximately pH 7.5 after 5 days owing to bacterial metabolism. After 13 days, the highest iron concentration was in the solution that was initially at pH 4 accompanied by pitting on the stainless steel. Sulfur was present on all specimens but with more sulfur at pH 4 in the EDX spectra. EIS showed the film resistance of the specimen at pH 4 was much lower than at pH 7.4 which suggests the corrosion resistance of the stainless steel was better at higher pH. The results of this study suggest that the corrosion process for the first few days exposure at low pH was driven by pH in solution rather than by bacteria. The increasing pH during the course of the experiment slowed down the corrosion process of materials originally at low pH. The nature and mechanism of SRB attack on duplex stainless steel at different acidic environments are discussed.Keywords
Funding Information
- Charles Darwin University RTP scholarship funding (1578028)
This publication has 38 references indexed in Scilit:
- Treatment of Groundwater Contaminated with PAHs, Gasoline Hydrocarbons, and Methyl tert-butyl Ether in a Laboratory Biomass-Retaining BioreactorBiodegradation, 2006
- A Thermodynamic Interpretation of Microbiologically Influenced CorrosionCorrosion, 2002
- Technical Note: Concerning the Conversion of the Constant Phase Element Parameter Y into a CapacitanceCorrosion, 2001
- Remediation of acidic waste waters using immobilised, acidophilic sulfate‐reducing bacteriaJournal of Chemical Technology & Biotechnology, 2001
- Effect of pH on the corrosion inhibition of mild steel in CO2 saturated brine solutionAnti-Corrosion Methods and Materials, 2000
- The influence of bacteria on the passive film stability of 304 stainless steelElectrochimica Acta, 1999
- Sulphate reduction by aggregates of sulphate-reducing bacteria and homo-acetogenic bacteria in a lab-scale gas-lift reactorBioresource Technology, 1995
- Effect of Elemental Sulfur on Corrosion in Sour Gas SystemsCorrosion, 1991
- The electrochemistry of SRB corrosion and related inorganic phenomena.ISIJ International, 1991
- Microbial sulfate reduction in acidic (pH 3) strip-mine lakesFEMS Microbiology Letters, 1990