A Rectification Topology for High-Current Isolated DC-DC Converters
Authors:
- Hong MaoHMHong Mao
- Issa E. BatarsehIBIssa E. Batarseh
- 9 July 2007
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Power Electronics
- Vol. 22 (4) , 1522-1530
Abstract
This paper presents a novel current tripler rectification (CTR) topology for secondary-side rectification in high-current low-voltage isolated dc-dc converters. Compared with the conventional center-tapped and current doubler rectifiers, the CTR topology has three filter inductors to share the output current, and thus higher current capability and better thermal management can be achieved. Theoretical analysis and experimental results verify that the proposed CTR is a good candidate for rectification topology in high-current dc-dc converters.Keywords
This publication has 6 references indexed in Scilit:
- A Novel Current Tripler Rectification Topology for Isolated DC-DC Converters in High Current Applications2006
- Comparison of Current Doubler Rectifier and Center Tapped Rectifier for Low Voltage Applications2006
- Design of 48 V Voltage regulator modules with a novel integrated magneticsIEEE Transactions on Power Electronics, 2002
- Design and performance evaluation of low-voltage/high-current DC/DC on-board modulesIEEE Transactions on Power Electronics, 2001
- Forward-flyback converter with current-doubler rectifier: analysis, design, and evaluation resultsIEEE Transactions on Power Electronics, 1999
- Small-signal modeling of pulse-width modulated switched-mode power convertersProceedings of the IEEE, 1988