Influence of FK209 Cobalt Doped Electron Transport Layer in Cesium Based Perovskite Solar Cells
Open Access
- 19 September 2022
- journal article
- research article
- Published by MDPI AG in Applied Sciences
- Vol. 12 (18) , 9382
Abstract
The efficiency and stability of perovskite solar cells (PSCs) depend not only on the perovskite film quality, but they are also influenced by the charge carriers of both the electron and hole transport layers (ETL and HTL). Doping of the carrier transport layers is considered one of effective technique applied to enhance the efficiency and performance of the PSCs. FK209 cobalt TFSI and lithium TFSI salt were investigated as dopants for mesoporous TiO2 (M-TiO2) in the ETL. Herein, FK209 cobalt doping offers improved conductivity, reproducibility and stability compared to other doping or undoped M-TiO2 control device. It has been found that an optimum concentration of 2.5 mg FK209 cobalt in the M-TiO2 has resulted in an efficiency of 15.6% on 0.36 cm2 active device area, whereas, the undoped M-TiO2 yielded an average efficiency of 10.8%. The enhanced efficiency is due to the improved conductivity of the ETL while maintaining high transparency and low surface roughness with FK209 doping. The M-TiO2 doped with FK209 has a transparency of the 90% over the visible range and its measured energy gap was 3.59 eV. Perovskite films deposited on the M-TiO2 doped with FK209 has also a lower PL intensity indicating faster charge extraction. The measured lifetime of the perovskite films deposited on the optimised M-TiO2 film was 115.8 ns.Keywords
Funding Information
- UC Doctoral Scholarship funding, University of Canterbury, New Zealand
- MacDiarmid Institute for Advanced Materials and Nanotechnology, New Zealand
This publication has 36 references indexed in Scilit:
- Efficient planar heterojunction perovskite solar cells with Li-doped compact TiO2 layerNano Energy, 2017
- Low-temperature solution-processed Li-doped SnO2 as an effective electron transporting layer for high-performance flexible and wearable perovskite solar cellsNano Energy, 2016
- Interface-Dependent Ion Migration/Accumulation Controls Hysteresis in MAPbI3 Solar CellsThe Journal of Physical Chemistry C, 2016
- Cesium Lead Halide Perovskites with Improved Stability for Tandem Solar CellsThe Journal of Physical Chemistry Letters, 2016
- Enhanced electronic properties in mesoporous TiO2 via lithium doping for high-efficiency perovskite solar cellsNature Communications, 2016
- Stability Issues on Perovskite Solar CellsPhotonics, 2015
- High-efficiency solution-processed perovskite solar cells with millimeter-scale grainsScience, 2015
- Perovskite Solar Cell with an Efficient TiO2 Compact FilmACS Applied Materials & Interfaces, 2014
- Band gap determination using absorption spectrum fitting procedureInternational Nano Letters, 2013
- Organometal Halide Perovskites as Visible-Light Sensitizers for Photovoltaic CellsJournal of the American Chemical Society, 2009