Influence of deposition pressure and pulsed dc sputtering on pumping properties of Ti–Zr–V nonevaporable getter films
- 17 April 2009
- journal article
- Published by American Vacuum Society in Journal of Vacuum Science & Technology A
- Vol. 27 (3) , 521-530
Abstract
The performance of a UHV vessel can be improved with a new CERN technology nonevaporable getter (NEG) coating, which is already widely used for accelerator vacuum chambers. Better understanding of the processes involved in NEG film deposition, activation, and poisoning should allow optimization and engineering of the film properties, which are necessary for a particular application. Ti–Zr–V NEG films were created by magnetron sputtering from a single Ti–Zr–V target, and the NEG performance and morphology dependence on deposition pressure, sputtering conditions, and substrate surface roughness have been investigated. It was found that the average grain size of the Ti–Zr–V film was 5–6 nm and was broadly independent of the substrate material and deposition conditions. However, film topography and density were shown to depend very much on the substrate surface roughness and deposition conditions. Rough substrates, high working pressures, and the absence of ion bombardment produced open columnar structures, whereas smooth substrates, ion assistance, and low pressures produced much denser layers. X-ray photoelectron spectroscopy studies have shown that full regeneration occurred at 300 °C but film activation started at temperatures of as low as 160 °C. The CO sticking probability reaches its maximum after activation at 250 °C and is found to be up to 0.3 with a pumping capacity in the range of 0.8–1.2 ML. The samples activated at 160 °C have a reduced pumping speed and capacity by an order of magnitude.Keywords
This publication has 10 references indexed in Scilit:
- Activation and measurement of nonevaporable getter filmsJournal of Vacuum Science & Technology A, 2009
- Test Particle Monte-Carlo modelling of installations for NEG film pumping properties evaluationVacuum, 2009
- Comparative study of photodesorption from TiZrV coated and uncoated stainless steel vacuum chambersVacuum, 2004
- Design of the vacuum system for Diamond, the UK third generation light sourceVacuum, 2004
- Vacuum properties of palladium thin film coatingsVacuum, 2004
- Synchrotron radiation-induced desorption from a NEG-coated vacuum chamberVacuum, 2001
- Ultimate pressures achieved in TiZrV sputter-coated vacuum chambersVacuum, 2001
- Decreasing surface outgassing by thin film getter coatingsVacuum, 1998
- Room temperature pumping characteristics for gas mixtures of a Zr–Al nonevaporable getterJournal of Vacuum Science & Technology A, 1990
- Room‐temperature pumping characteristics of a Zr–Al nonevaporable getter for individual gasesJournal of Vacuum Science & Technology A, 1988