Laser Surface Alloying of Austenitic 316L Steel with Boron and Some Metallic Elements: Properties
Open Access
Abstract
Austenitic 316L stainless steel is known for its good resistance to corrosion and oxidation. However, under conditions of appreciable mechanical wear, this steel had to demonstrate suitable wear protection. In this study, laser surface alloying with boron and some metallic elements was used in order to improve the hardness and wear behavior of this material. The microstructure was described in the previous paper in detail. The microhardness was measured using Vickers method. The “block-on-ring” technique was used in order to evaluate the wear resistance of laser-alloyed layers, whereas, the potentiodynamic method was applied to evaluate their corrosion behavior. The produced laser-alloyed layers consisted of hard ceramic phases (Fe2B, Cr2B, Ni2B or Ni3B borides) in a soft austenitic matrix. The significant increase in hardness and wear resistance was observed in the case of all the laser-alloyed layers in comparison to the untreated 316L steel. The predominant abrasive wear was accompanied by adhesive and oxidative wear evidenced by shallow grooves, adhesion craters and the presence of oxides. The corrosion resistance of laser-alloyed layers was not considerably diminished. The laser-alloyed layer with boron and nickel was the best in this regard, obtaining nearly the same corrosion behavior as the untreated 316L steel.Keywords
Funding Information
- Ministerstwo Edukacji i Nauki (0513/SBAD/4739)
This publication has 69 references indexed in Scilit:
- Effect of surface mechanical attrition treatment (SMAT) on pack boronizing of AISI 304 stainless steelSurface and Coatings Technology, 2013
- Low-temperature carburised AISI 316L austenitic stainless steel: Wear and corrosion behaviourMaterials & Design (1980-2015), 2012
- Modifying the properties of AISI 316L steel by glow discharge assisted low-temperature nitriding and oxynitridingVacuum, 2010
- Characterization of expanded austenite developed on AISI 316L stainless steel by plasma carburizationSurface and Coatings Technology, 2010
- Laser-fabricated Fe–Ni–Co–Cr–B austenitic alloy on steels. Part I. Microstructures and cavitation erosion behaviourSurface and Coatings Technology, 2001
- Improvement of the wear resistance of 316L stainless steel by laser surface alloyingSurface and Coatings Technology, 1996
- Carbide-reinforced coatings on AISI 316 L stainless steel by laser surface alloyingSurface and Coatings Technology, 1995
- Chromium carbide laser-beam surface-alloying treatment on stainless steelJournal of Materials Science, 1992
- Wear-mechanism mapsScripta Metallurgica et Materialia, 1990
- Particulate-TiC-hardened steel surfaces by laser melt injectionThin Solid Films, 1980