Comparing tensile, bending and interlaminar shear performance of GFRP composites fabricated using recovered and virgin glass fibers: Optimization of the microwave assisted chemical recycling technique
- 27 August 2024
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 45 (18) , 17150-17165
Abstract
Global glass fiber reinforced plastic (GFRP) recycling provides an effective solution to the end‐of‐life wastes and industrial scrap, by which we can construct a closed‐loop system that reduces environmental impact while increasing sustainability. This study reports the tensile, flexural and shear properties of GFRP composites fabricated from reclaimed fibers from the waste GFRP. A hybrid recycling technique that is, microwave assisted chemical recycling has been used for recovering the glass fiber fabrics. The quantity of solvents (a mixture of 30% H2O2 and CH3COOH in 1:1 ratio) required (in mL/g) for degrading the polymer is optimized with respect to the amount of microwave irradiation time. The microwave irradiation duration was varied at constant power of 900 W for optimizing the quantity of solvent used. SEM analysis of both virgin and reclaimed fiber surfaces indicate an almost complete degradation of polymer from the waste composites. RGFE laminates, fabricated from reclaimed glass fiber fabrics, exhibited marginally higher tensile strength (7%–8%) and significant lower tensile modulus (~29%). On the other hand, RGFE composites demonstrated a greater strain to failure of ~44% compared to VGFE composites during tensile testing, consequently leading to a subsequent increase in tensile toughness by ~28%. The ILSS values obtained from SBS tests and storage modulus and loss factor curves from DMA tests showed almost similar values. SEM studies revealed the probable causes of failures of the samples for tensile and flexural tests.Highlights: Hybrid recycling technique using microwave irradiation is optimized. Amount of solvent used is optimized by varying the irradiation times. Tensile and flexural strengths exhibit a marginal increase of 7%–8%. Significant rise in strain at failure by 44% and tensile toughness by 28%. Fractography studies have been performed for analyzing failures.Keywords
Funding Information
- National Institute of Technology Rourkela
This publication has 20 references indexed in Scilit:
- Recycling of glass fibre reinforced polymer (GFRP) composite wastes in concrete: A critical review and cost benefit analysisStructures, 2023
- Evolution of fibre deflection leading to kink-band formation in unidirectional glass fibre/epoxy composite under axial compressionComposites Science and Technology, 2021
- Characterization of the interlaminar shear strength of IM7/8552 using small-scale short beam shear testsComposites Part A: Applied Science and Manufacturing, 2021
- A Comparative Life Cycle Assessment between landfilling and Co-Processing of waste from decommissioned Irish wind turbine bladesJournal of Cleaner Production, 2020
- Novel carbon-fibre powder-epoxy composites: Interface phenomena and interlaminar fracture behaviourComposites Part B: Engineering, 2019
- Design of Oil and Gas Composite Pipes for Energy ProductionEnergy Procedia, 2019
- High voltage fragmentation and mechanical recycling of glass fibre thermoset compositeCIRP Annals, 2016
- Reusing textile waste as reinforcements in compositesJournal of Applied Polymer Science, 2014
- Recycling of composite materialsChemical Engineering and Processing - Process Intensification, 2012
- Recycling technologies for thermoset composite materials—current statusComposites Part A: Applied Science and Manufacturing, 2006