Simulation of 500 kHz High Frequency Transformer Temperature Rise under Different Wave Excitation
Authors:
- 6 September 2020
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 1-4
Abstract
High-frequency transformers are widely used in the field of power electronic DC transmission. However, the loss and heat caused by high-frequency wave contradict the demand for minimizing transformer size. In this paper, finite element analysis method is used to build the transformer simulation model considering the correction coefficients of the high-frequency square wave. The temperature distribution with varied frequency is shown. Results show that the losses under square wave are lower than those under sinusoidal wave. With the increase of voltage frequency, the overall temperature falls first and then rises. The hotspots are located on the inner side of the magnetic core and the low-voltage winding. By introducing the design of fins, the temperature of the hottest part can be lowered by 100°C. As the thermal conductivity of epoxy resin increases, the transformer overall temperature decreases significantly. And it is proposed that increasing the number of winding layers could extend the working frequency range of the transformers. The research provides some theoretical basis for the subsequent selection of high-frequency transformer materials and structural design.Keywords
Funding Information
- National Natural Science Foundation of China (51907101)
- Natural Science Foundation of Beijing Municipality (3204044)
- China Postdoctoral Science Foundation (2019M650029)
This publication has 9 references indexed in Scilit:
- Research on the Relation between Load Coefficient and Hot Spot Temperature of Oil-immersed Power Transformer2019
- Effects of high thermal conductivity on temperature rise of epoxy cast winding for power transformerIEEE Transactions on Dielectrics and Electrical Insulation, 2016
- Effect of higher insulation material thermal conductivity on transformer temperature rise2016
- Thermal analysis using 3D FEM model of oil-immersed distribution transformer2016
- Calculating model of insulation life loss of dry- type transformer based on the hot-spot temperature2015
- 3-D Coupled Electromagnetic-Fluid-Thermal Analysis of Oil-Immersed Triangular Wound Core TransformerIEEE Transactions on Magnetics, 2014
- Predicting iron losses in soft magnetic materials with arbitrary voltage supply: an engineering approachIEEE Transactions on Magnetics, 2003
- Accelerated aging tests on magnet wires under high frequency pulsating voltage and high temperature2003
- Effects of eddy currents in transformer windingsProceedings of the Institution of Electrical Engineers, 1966