A New Approach for Microfabrication of Printed Circuit Boards with Ultrafine Traces
- 4 September 2019
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 11 (38) , 35376-35381
Abstract
The advances in micro/nanofabrication techniques have enabled miniaturization of printed circuit boards for various applications including portable devices, smart sensors, and IoTs to name a few. Printed circuit boards provide electrical connectivity between the components as well as mechanically support. Down-scaling of printed circuit boards is crucial for miniaturization of large systems and devices. Micro-traces down to 25 µm can be microfabricated with the current microfabrication processes. In the present work, we report a new approach for micro-fabrication of printed circuit boards with trace widths down to 3 microns on commercially available PCB substrates. We used electroplating/electroetching, sputtering, and photolithography to achieve these fine trace sizes. The proposed fabrication technique can be used in microelectronics, system on chip (SoC), MEMS, and miniaturized circuits and systems in general.Keywords
Funding Information
- Bill and Melinda Gates Foundation (1136638)
This publication has 17 references indexed in Scilit:
- A fully electronic microfabricated gas chromatograph with complementary capacitive detectors for indoor pollutantsMicrosystems & Nanoengineering, 2016
- Optimization of the force and power consumption of a microfabricated magnetic actuatorSensors and Actuators A: Physical, 2015
- Technologies for Printing Sensors and Electronics Over Large Flexible Substrates: A ReviewIEEE Sensors Journal, 2014
- Ultra-fine trench circuit on polymer film2013
- Materials and Mechanics for Stretchable ElectronicsScience, 2010
- Direct-Referencing Two-Dimensional-Array Digital Microfluidics Using Multilayer Printed Circuit BoardJournal of Microelectromechanical Systems, 2008
- A fast switching bistable electromagnetic microactuator fabricated by UV-LIGA technologyMechatronics, 2007
- Microfabricated solenoids and Helmholtz coils for NMR spectroscopy of mammalian cellsLab on a Chip, 2007
- An economic analysis of the deposition of electrochromic WO3 via sputtering or plasma enhanced chemical vapor depositionMaterials Science and Engineering: B, 2005
- Gas-assisted etching with focused ion beam technologyMicroelectronic Engineering, 1994