Viscosity and Microstructure of Polyethylene‐Poly(Methyl Methacrylate) Melt Blends: Some Simple Interpretations

Authors:
  • CMCesar B. Martinez
    Cesar B. Martinez
  • MWMichael C. Williams
    Michael C. Williams

Abstract
In an experimental study of polyethylene (PE) and poly(methyl methacrylate)(PMMA) blends, complex viscosityη*(ω)=η′−iη″ and non‐Newtonian viscosityη(γ̇) were obtained with a Weissenberg rheogoniometer operating in a cone‐and‐plate mode at 160 °C. Blends were prepared by a standardized melt mixing for volume fractions φ from φ=0(PE) to 1.0 (PMMA) at increments of Δφ=0.1. The PMMA was more viscous than PE at all conditions of ω and γ̇, their viscosity ratio being 5.9 in the Newtonian η0 limit. Scanning electron micrographs were taken of freeze‐fracture planes in all samples prior to testing. A maximum in both η and η′ was found near φ=0.9 and an apparent step increase of viscosity level in the vicinity of 0.5–0.6 at all ω and γ̇. The maximum is quantitatively explained in the Newtonian limit by well‐established viscosity predictions for dilute two‐phase emulsions with spherical droplets; this model is equally successful for φ=0.1 (the other dilute regime) and, in both cases, valid also within 5–10% for a substantial range of ω‐ and γ̇‐dependent data. The step increase is attributed to phase inversion, but smooth interpolation between φ=0.1 and 0.9 is found to yield rather good empirical predictions for intermediate compositions without recourse to microstructural information. Rather conventional behavior is seen in comparisons of η(γ̇) with η′(ω) and |η*|, the latter upholding the Cox‐Merz approximation η=|η*| rather well. Exceptions to these are noted in the intermediate φ range, but only in the η0 limit after high‐γ̇ testing, and the discrepancies are suspected to arise from microstructural alterations during steady shear.