Physically Based Impedance Modeling of Ni/YSZ Cermet Anodes
- 1 January 2008
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 155 (9) , B937-B952
Abstract
The electrochemical impedance of Ni/yttria-stabilized zirconia (YSZ) cermet anodes is generally observed to consist of multiple features that can span the entire frequency range from hertz to megahertz. In order to assign the origin of these features, we apply a two-dimensional multiscale modeling approach that includes elementary kinetic electrochemistry, electrical double-layer formation, diffusive transport in the porous cermet and the current collector mesh, gas-phase transport in the supply channel, and cermet microstructure description based on percolation theory. The model parameters are chosen to represent the electrolyte-supported symmetrical cell setup of Sonn et al. [ J. Electrochem. Soc. , 155 , B675 (2008)] . The experimental data show three distinct impedance features. Using sensitivity analysis and model reductions, the physical model allows the assignment of the origin of these impedance features: (i)(i) distributed charge transfer and electrical double layer cause an asymmetrical and depressed semicircle at high frequencies (∼5kHz)(∼5kHz) ; (ii)(ii) gas diffusion in the cermet and current collector mesh causes a small feature at intermediate frequencies (∼1kHz)(∼1kHz) ; and (iii)(iii) gas diffusion in the supply channels causes a large, sometimes dominant feature at low frequencies (∼6Hz)(∼6Hz) . Two-dimensional spatial and temporal evolution of electrical current, potential, and gas composition during the impedance measurement are discussed.Keywords
This publication has 48 references indexed in Scilit:
- Evaluation and Modeling of the Cell Resistance in Anode-Supported Solid Oxide Fuel CellsJournal of the Electrochemical Society, 2008
- A new framework for physically based modeling of solid oxide fuel cellsElectrochimica Acta, 2007
- Rapid Impedance Modeling via Potential Step and Current Relaxation SimulationsJournal of the Electrochemical Society, 2007
- Three-dimensional reconstruction of a solid-oxide fuel-cell anodeNature Materials, 2006
- Modelling of multi-component gas flows in capillaries and porous solidsInternational Journal of Heat and Mass Transfer, 2005
- State-space modeling of the anodic SOFC system Ni, H2–H2O∣YSZSolid State Ionics, 2002
- Micro-modelling of solid oxide fuel cell electrodesElectrochimica Acta, 1998
- Calculations of impedance of composite anodes for solid oxide fuel cellsElectrochimica Acta, 1997
- Relation between percolation and particle coordination in binary powder mixturesActa Metallurgica et Materialia, 1991
- Estimation of the Co-ordination number in a Multi-Component Mixture of SpheresPowder Technology, 1983