Bit-Error-Rate Estimation for High-Speed Serial Links
Authors:
- Dongwoo HongDHDongwoo Hong
- Chee-Kian OngCOChee-Kian Ong
- Kwang-Ting ChengKCKwang-Ting Cheng
- 11 December 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 53 (12) , 2616-2627
Abstract
High-performance serial communication systems often require the bit error rate (BER) to be at the level of 10-12 or lower. The excessive test time for measuring such a low BER is a major hindrance in testing communication systems. In this paper, we show that the jitter spectral information extracted from the transmitted data and some key characteristics of the clock and data recovery (CDR) circuit can be used to estimate the BER effectively without comparing each captured bit for error detection. This analysis is also useful for designing a CDR circuit for systems whose jitter spectral information is known. Experimental results comparing the estimated and measured BER on a 2.5-Gb/s commercial CDR circuit demonstrate the high accuracy of the proposed techniqueKeywords
This publication has 16 references indexed in Scilit:
- A 6.25-Gb/s binary transceiver in 0.13-/spl mu/m CMOS for serial data transmission across high loss legacy backplane channelsIEEE Journal of Solid-State Circuits, 2005
- Clocking and circuit design for a parallel I/O on a first-generation CELL processor2005
- Autonomous dual-mode (PAM2/4) serial link transceiver with adaptive equalization and data recoveryIEEE Journal of Solid-State Circuits, 2005
- BER estimation for serial links based on jitter spectrum and clock recovery characteristics2005
- 8-Gb/s source-synchronous I/O link with adaptive receiver equalization, offset cancellation, and clock de-skewIEEE Journal of Solid-State Circuits, 2005
- Jitter spectral extraction for multi-gigahertz signal2004
- Paradigm shift for jitter and noise in design and test < Gb/s communication systems (an invited paper for ICCD 2003)2004
- Modeling and analysis of high-speed links2004
- A new method for jitter decomposition through its distribution tail fitting2003
- Jitter testing for gigabit serial communication transceiversIEEE Design & Test of Computers, 2002