Behaviour of piled embankment without reinforcement
- 30 September 2015
- journal article
- Published by Emerald Publishing in Proceedings of the Institution of Civil Engineers - Geotechnical Engineering
- Vol. 168 (6) , 514-525
Abstract
A programme of 20 centrifuge tests was carried out on piled embankments without reinforcement to assess the influence of geometric parameters on surface settlement and on the load transfer mechanism. The three main geometric parameters studied were pile spacing, embankment height and area ratio, which were varied in ranges commonly adopted in practice. The measurements of the forces on the piles allowed assessment of the load transfer mechanisms, and thus the efficiency, which were shown to increase with embankment height and area ratio. Subsoil stress between piles was also assessed and compared with literature data. The centrifuge model test results for stress on the subsoil at the point of ‘maximum arching’ presented good agreement with the method proposed by Hewlett and Randolph in 1988. Measurements of the surface settlements allowed evaluation of the critical height at which surface differential settlements did not occur. The values of critical height obtained herein are in good agreement with recent literature recommendations.Keywords
This publication has 27 references indexed in Scilit:
- Geosynthetic reinforcement of a granular load transfer platform above rigid inclusions: comparison between centrifuge testing and analytical modellingGeosynthetics International, 2014
- Design and Performance of Embankments on Very Soft Soils2013
- Centrifuge investigation of load transfer mechanisms in a granular mattress above a rigid inclusions networkGeotextiles and Geomembranes, 2013
- Visualization of soil arching on reinforced embankment with rigid pile foundation using X-ray CTGeotextiles and Geomembranes, 2012
- Column-Supported Embankments: Settlement and Load Transfer2012
- Performance of Pile-Supported Embankment over Soft Soil: Full-Scale ExperimentJournal of Geotechnical and Geoenvironmental Engineering, 2012
- Physical modeling of debris flows over flexible ring net barriers2010
- An experimental investigation of soil arching within basal reinforced and unreinforced piled embankmentsGeotextiles and Geomembranes, 2008
- Embankment supported on piles with biaxial geogridsProceedings of the Institution of Civil Engineers - Geotechnical Engineering, 2007
- Behaviour of geogrid-reinforced load transfer platforms for embankment on rammed aggregate piersGeosynthetics International, 2007