Engineered polarization control of GaAs/AlGaAs surface-emitting lasers by anisotropic stress from elliptical etched substrate hole
Authors:
- 1 February 1993
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 5 (2) , 133-135
Abstract
The engineered polarization control of surface emitting (SE) lasers, based on the observed evidence of the polarization determination, is reported. Thermally stressed epitaxial layers including an active region are made anisotropic by an elliptically etched substrate structure. This stress causes an anisotropy in optical gain of the active region. The polarization control has been demonstrated with about 80% reproducibility in etched-well-type surface emitting (SE) lasers by employing a thick gold film or a polyimide as a stress-enhancing material.Keywords
This publication has 12 references indexed in Scilit:
- Polarisation control for surface emitting lasersElectronics Letters, 1991
- Dynamic, polarization, and transverse mode characteristics of vertical cavity surface emitting lasersIEEE Journal of Quantum Electronics, 1991
- A Method of Polarization Stabilization in Surface Emitting LasersJapanese Journal of Applied Physics, 1991
- High-order transverse modes of top-surface-emitting lasers with various symmetries and sizes: a video demonstration1990
- Polarization Characteristics of MOCVD Grown GaAs/GaAlAs CBH Surface Emitting LasersJapanese Journal of Applied Physics, 1988
- Effect of uniaxial stress on optical gain in semiconductorsJournal of Applied Physics, 1984
- Calculated stresses in multilayered heteroepitaxial structuresJournal of Applied Physics, 1977
- Behavior of threshold current and polarization of stimulated emission of GaAs injection lasers under uniaxial stressIEEE Journal of Quantum Electronics, 1973
- Thermal Expansion of AlAsJournal of Applied Physics, 1970
- Coefficient of Expansion of GaAs, GaP, and Ga(As, P) Compounds from −62° to 200°CJournal of Applied Physics, 1967