Three‐dimensional modelling of an isolated carbonate buildup (Triassic, Dolomites, Italy)
- 15 April 2004
- journal article
- research article
- Published by Wiley in Sedimentology
- Vol. 51 (2) , 297-314
Abstract
The Middle Triassic carbonate buildups of the Dolomites show facies similarities with mud mounds but display apparent architectural elements of flat‐topped carbonate platforms. In order to test whether the facies similarities to mounds are also reflected in the internal buildup architecture, a three‐dimensional modelling study of the Middle Triassic Monte Cernera buildup has been carried out. The Cernera buildup exhibits apparent geometries suggesting a mounded platform in the lower and uppermost part of the buildup, separated by an interval with apparent platform geometry and a retrogradational platform interior, which is difficult to explain with a flat top platform model. For this purpose, a number of three‐dimensional models were constructed using the three‐dimensional modelling programme petrelTM. Key geological horizons were constructed based on outcrop measurements, intermediate horizons were calculated in the modelling program, and the intersections of the modelled layers with a digital topography surface were displayed and compared with outcrop photographs. The models were refined stepwise until a best fit with the actual bedding architecture was achieved. The best fit model shows that the mounded geometries in the lower and uppermost part of the buildup are real architectural elements. The intermediate platform stage, about 1·5 km across, had probably retained a mounded top with a relief of up to 50 m, which is difficult to distinguish from an absolutely flat top, but necessary to explain the retrogradational platform interior. The present study shows that Monte Cernera was dominated by mounded geometries at all stages of platform development. The mounded geometry plus facies data suggest that the platform is a deep‐water accumulation, below the zone of intense wave energy, but within the photic zone. The Cernera represents a tropical buildup type, which did not have the capacity to grow into continuously wave‐swept environments because of the small size and the absence of a wave‐resistant energy barrier. Such buildup types are probably common after major crises in earth history, when reef organisms were virtually absent.Keywords
This publication has 17 references indexed in Scilit:
- High-resolution magnetostratigraphic and lithostratigraphic correlations in Middle Triassic pelagic carbonates from the Dolomites (northern Italy)Palaeogeography, Palaeoclimatology, Palaeoecology, 2000
- A steep‐fronted Carboniferous carbonate platform: clinoformal geometry and lithofacies (Picos de Europa, NW Spain)Sedimentology, 2000
- Facies architecture of an isolated carbonate platform: tracing the cycles of the Latemàr (Middle Triassic, northern Italy)Sedimentology, 1999
- Growth and demise of Late Carboniferous carbonate platforms in the eastern Cantabrian Zone, Asturias, northwestern SpainSedimentary Geology, 1997
- The carbonate factory of Middle Triassic buildups in the Dolomites, Italy: a quantitative analysisSedimentology, 1994
- High frequency glacio-eustatic sealevel oscillations with Milankovitch characteristics recorded in Middle Triassic platform carbonates in northern ItalyAmerican Journal of Science, 1987
- Isolated stationary carbonate platforms: the Middle Triassic (Ladinian) of the Marmolada area, Dolomites, ItalySedimentology, 1986
- Progradation geometries of carbonate platforms: examples from the Triassic of the Dolomites, northern ItalySedimentology, 1984
- Microfacies Analysis of Limestones1982
- Triassic Carbonate Buildups of the Dolomites, Northern Italy1974