A new pulsed laser deposition technique: Scanning multi-component pulsed laser deposition method
- 1 April 2012
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 83 (4) , 043901
Abstract
The scanning multi-component pulsed laser deposition (PLD) method realizes uniform depositions of desired coatings by a modified pulsed laser deposition process, preferably with a femto-second laser-system. Multi-component coatings (single or multilayered) are thus deposited onto substrates via laser induced ablation of segmented targets. This is achieved via horizontal line-scanning of a focused laser beam over a uniformly moving target's surface. This process allows to deposit the desired composition of the coating simultaneously, starting from the different segments of the target and adjusting the scan line as a function of target geometry. The sequence and thickness of multilayers can easily be adjusted by target architecture and motion, enabling inter/intra layer concentration gradients and thus functional gradient coatings. This new, simple PLD method enables the achievement of uniform, large-area coatings. Case studies were performed with segmented targets containing aluminum, titanium, and niobium. Under the laser irradiation conditions applied, all three metals were uniformly ablated. The elemental composition within the rough coatings obtained was fixed by the scanned area to Ti-Al-Nb = 1:1:1. Crystalline aluminum, titanium, and niobium were found to coexist side by side at room temperature within the substrate, without alloy formation up to 600 °C.Keywords
This publication has 37 references indexed in Scilit:
- Laser deposition of large-area thin filmsQuantum Electronics, 2011
- Recent advances in pulsed-laser deposition of complex oxidesJournal of Physics: Condensed Matter, 2008
- Femtosecond laser ablation of nickel in vacuumJournal of Physics D: Applied Physics, 2007
- Industrially-styled room-temperature pulsed laser deposition of titanium-based coatingsVacuum, 2005
- Cross-beam pulsed laser deposition: General characteristicReview of Scientific Instruments, 2001
- Three simple methods to obtain large area thin films by pulsed laser depositionIEEE Transactions on Applied Superconductivity, 2001
- Pulsed laser deposition apparatus for applied researchMeasurement Science and Technology, 1999
- A fully automated pulsed laser deposition system for HTS multilayer devicesIEEE Transactions on Applied Superconductivity, 1995
- Precise measurement of lattice parameters of pseudocubic latticesActa Crystallographica Section A, 1972
- The anisotropy of the thermal expansion of α-titaniumActa Crystallographica Section A, 1968