Experiments of drilling micro-holes on superalloy with thermal barrier coatings by using femtosecond laser
- 17 August 2020
- journal article
- research article
- Published by Taylor & Francis in Ferroelectrics
- Vol. 564 (1) , 37-51
Abstract
A femtosecond laser was used to process micro-holes on the nickel-based superalloy with thermal barrier coatings. Scanning electron microscope (SEM) was used to observe the morphology of micro-holes inlet, outlet and the side wall. The changes of morphology with laser focusing position and laser power were analyzed. The results showed that the micro-holes processed by femtosecond laser required a certain amount of focus position to optimize the processing quality. The entrance was not round sometimes and the micro-holes outlet was irregular with high power laser machining. A further repair of micro-hole by using low power femtosecond laser was presented. Low laser power modification can improve the quality of micro-holes.Keywords
This publication has 67 references indexed in Scilit:
- Molecular dynamics study of the positioned single-walled carbon nanotubes with T-, X-, Y- junction during nanoscale solderingApplied Surface Science, 2013
- Simulation study of near-field enhancement on a laser-irradiated AFM metal probeLaser Physics, 2013
- Nanowelding configuration between carbon nanotubes in axial directionApplied Surface Science, 2013
- Particles nanomanipulation by the enhanced evanescent field through a near-field scanning optical microscopy probeSensors and Actuators A: Physical, 2011
- Modeling of ultrashort laser pulse-train processing of metal thin filmsInternational Journal of Heat and Mass Transfer, 2007
- Femtosecond laser machining of single-crystal superalloys through thermal barrier coatingsMaterials Science and Engineering: A, 2006
- Deep drilling of metals with ultrashort laser pulses: A two-stage processJournal of Applied Physics, 2006
- Femtosecond laser micromachining of a single-crystal superalloyScripta Materialia, 2005
- Machining of low electrical conductive materials by wire electrical discharge machining (WEDM)Journal of Materials Processing Technology, 2004
- Laser drilling of cooling holes through plasma sprayed thermal barrier coatingsSurface and Coatings Technology, 2004