Power factor correction in switched mode power supply for computers using canonical switching cell converter
Open Access
- 1 February 2015
- journal article
- research article
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 8 (2) , 234-244
Abstract
This study presents a novel power factor correction (PFC) technique using a canonical switching cell (CSC) converter applicable to multi‐output switched mode power supply (SMPS) used in personal computers (PCs). The CSC converter at the front end of this single‐phase fed SMPS operates in discontinuous conduction mode that offers inherent PFC for wide range of varying input voltages. It is cascaded to an isolated half‐bridge multi output dc–dc converter for obtaining multiple dc voltages that are stiffly regulated and isolated from each other as per the requirement of the PC. The proposed SMPS is designed, modelled and its performance is investigated under steady state and dynamic operating conditions for varying input voltages and loads. It is found that the proposed design is able to offer excellent power factor and low total harmonics distortion at the utility interface as shown in investigations carried on simulation and experimental studies. A comparison of conventional SMPS with proposed PFC‐based SMPS vividly brings out the merits of the latter. Further, a comparison is made with other types of front end converters to investigate the relative merits and demerits of the CSC converter over other front end converters.Keywords
This publication has 23 references indexed in Scilit:
- Buck converter‐based power supply design for low power light emitting diode lamp lightingIET Power Electronics, 2014
- Generation and Analysis of Canonical Switching Cell DC-to-DC ConvertersIEEE Transactions on Industrial Electronics, 2013
- Comprehensive Study of Single-Phase AC-DC Power Factor Corrected Converters With High-Frequency IsolationIEEE Transactions on Industrial Informatics, 2011
- Two-Stage Isolated Switch-Mode Power Supply With High Efficiency and High Input Power FactorIEEE Transactions on Industrial Electronics, 2010
- Novel circuit design for two-stage AC/DC converter to meet standby power regulationsIET Power Electronics, 2009
- Control loop design for two-stage DC-DC converters with low voltage/high current outputIEEE Transactions on Power Electronics, 2005
- Zero-Voltage-Switching Half-Bridge DC–DC Converter With Modified PWM Control MethodIEEE Transactions on Power Electronics, 2004
- The influence of personal computer processing modes on line current harmonicsIEEE Transactions on Power Delivery, 2003
- A review of single-phase improved power quality ac~dc convertersIEEE Transactions on Industrial Electronics, 2003
- Power quality characteristics of computer loadsIEEE Transactions on Industry Applications, 1997