Optimal design of a three-pole active magnetic bearing
Authors:
- Chan-Tang HsuCHChan-Tang Hsu
- 10 December 2002
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Magnetics
- Vol. 38 (5) , 3458-3466
Abstract
The active magnetic bearing (AMB) is an important element for high-speed systems, such as semiconductor equipment and machine tools. The most popular AMB has eight magnetic poles. We propose a three-pole AMB here. Compared with the eight-pole configuration, it has the advantages of fewer power amplifiers, lower iron loss, and more space for heat dissipation, coil winding, and sensor installation. As a result, the AMB's overall cost can be reduced. Here, we study the three-pole AMB's optimal design, one that minimizes both the number of power amplifiers and the steady-state copper loss. Four design variables are considered: bias current, pole orientation angle, number of coil turns, and pole face. The optimal bias currents minimizing the steady-state copper loss are obtained by the method of Lagrange's multiplier. The coil turns and pole face area are optimal if they occupy equal available bearing space. The optimal three-pole AMB is Y-shaped, i.e., the pole orientation angle is /spl pi//6. With this optimal pole orientation, the AMB's two upper poles can share the same bias and control currents, but with opposite winding directions. Thus, only two power amplifiers are required for the optimal three-pole AMB. Finally, it is shown that the three-pole AMB possesses lower steady-state copper loss than the eight-pole AMB.Keywords
This publication has 16 references indexed in Scilit:
- A self-sensing homopolar magnetic bearing: analysis and experimental results2003
- Experiences using RT-Linux to implement a controller for a high speed magnetic bearing system2003
- Position sensed and self-sensing magnetic bearing configurations and associated robustness limitations2002
- Modeling and robust control of self-sensing magnetic bearings with unbalance compensation2002
- Nonlinear control with digital signal processors: room for improvement2002
- A multitasking DSP implementation of adaptive magnetic bearing controlIEEE Transactions on Control Systems Technology, 1997
- Digitally controlled transducerlessmagnetic suspension systemIEE Proceedings - Science, Measurement and Technology, 1996
- Stability analysis of self-sensing magnetic bearing controllersIEEE Transactions on Control Systems Technology, 1996
- New concepts for cost-effective magnetic bearing controlAutomatica, 1994
- Self-sensing active magnetic levitationIEEE Transactions on Magnetics, 1993