Constitutive modelling with a novel two-step optimization for an Al-Zn-Mg-Cu alloy and its application in FEA
Authors:
Open Access
- 1 November 2021
- journal article
- research article
- Published by IOP Publishing in Materials Research Express
- Vol. 8 (11) , 116511
Abstract
The modified Johnson-Cook constitutive model was developed for describing the flow behavior of Al-7.8Zn-1.65Mg-2.0Cu (wt%) alloy based on the flow curves in the temperature range of 300 °C∼450 °C and strain rate range of 0.01 s−1 ∼ 10 s−1 which were obtained by isothermal compression tests conducted on a Gleeble-3500 isothermal simulator. A two-step optimization method was proposed to optimize the prediction precision according to the evaluation of average absolute relative error (AARE). By using a traversal procedure for calculating the model under different reference conditions, this evaluator was found varying in the range of 4.1837% ∼ 11.105%, revealing the great influence of reference condition on the precision, then the reference condition optimization (RCO) was conducted. Genetic algorithm (GA) was introduced as the second step of the two-step optimization (TSO) to optimize the material constants of the model, which furtherly improved the precision by reducing the AARE-value to 3.801%. The models before and after optimization were written into subroutines for the software DEFORM and the compression tests were investigated through finite element analysis (FEA). The simulated results (forming load and temperature rise) revealed that the model after TSO has the highest agreement with the experimental.Keywords
Funding Information
- research project supported by Chongqing University of Science and Technology (ckrc2020015)
- Foundation of Science and Technology project of Chongqing Education Commission (KJQN202101515)
This publication has 39 references indexed in Scilit:
- A modified Zerilli–Armstrong constitutive model to predict hot deformation behavior of 20CrMo alloy steelMaterials & Design (1980-2015), 2014
- Prediction of flow curves and forming limit curves of Mg alloy thin sheets using ANN-based modelsComputational Materials Science, 2011
- Flow curve prediction of Al–Mg alloys under warm forming conditions at various strain rates by ANNApplied Soft Computing, 2011
- A modified Johnson–Cook model for tensile behaviors of typical high-strength alloy steelMaterials Science and Engineering: A, 2010
- A comparative study on Johnson Cook, modified Zerilli–Armstrong and Arrhenius-type constitutive models to predict elevated temperature flow behaviour in modified 9Cr–1Mo steelComputational Materials Science, 2009
- A comparative study of a back propagation artificial neural network and a Zerilli–Armstrong model for pure molybdenum during hot deformationInternational Journal of Refractory Metals and Hard Materials, 2007
- The Adiabatic Correction Factor for Deformation Heating During the Uniaxial Compression TestJournal of Materials Engineering and Performance, 2001
- Dynamic recrystallization during hot deformation of aluminum: A study using processing mapsMetallurgical Transactions A, 1991
- Overview no. 35 Dynamic recrystallization: Mechanical and microstructural considerationsActa Metallurgica, 1984
- On the mechanism of hot deformationActa Metallurgica, 1966