Influence of electrolyte constituents on corrosion behaviour of PEO coatings on magnesium alloys
Authors:
- 1 July 2010
- journal article
- Published by SAGE Publications in Surface Engineering
- Vol. 26 (5) , 321-327
Abstract
AM50 magnesium alloy is treated by PEO process using four different electrolytes which are combination of K3PO4 and Na3PO4 plus two different hydroxides, i.e. KOH and NaOH. Basic properties of the electrolyte such as pH, conductivity and breakdown voltage were measured. Moreover, coatings were characterised by scanning electron microscopy for the surface morphology and cross sectional study, X-ray diffraction for determination of phase composition and electrochemical impedance spectroscopy (EIS) for evaluation of corrosion resistance. The results indicate that KOH solutions need higher breakdown voltage and result in higher thickness of coatings. The values of the latter parameters are in the range of 150–160 V and 14–17 μm respectively. While those of NaOH solutions are in the range of 106–116 V and 5–6 μm thick. The final results show that presence of KOH in the solutions leads to a better corrosion performance of the coating compared to NaOH.Keywords
This publication has 25 references indexed in Scilit:
- Structure and mechanical properties of magnesium alloy treated by micro-arc discharge oxidation using direct current and high-frequency bipolar pulsing modesMaterials Science and Engineering: A, 2006
- Porosity in plasma electrolytic oxide coatingsActa Materialia, 2006
- Electrochemical corrosion behavior of composite coatings of sealed MAO film on magnesium alloy AZ91DElectrochimica Acta, 2006
- Electrochemical performance of microarc oxidation films formed on AZ91D magnesium alloy in silicate and phosphate electrolytesSurface and Coatings Technology, 2006
- Effects of spark discharge on the anodic coatings on magnesium alloyMaterials Letters, 2006
- Influence of process parameters on the corrosion properties of electrolytic conversion plasma coated magnesium alloysSurface and Coatings Technology, 2005
- Formation, structure and composition of anodic films on AM60 magnesium alloy obtained by DC plasma anodisingCorrosion Science, 2005
- Effects of Na2SiO3 on anodization of Mg–Al–Zn alloy in 3 M KOH solutionCorrosion Science, 2004
- Plasma electrolytic fabrication of oxide ceramic surface layers for tribotechnical purposes on aluminium alloysSurface and Coatings Technology, 1998
- Properties of synthesised oxide-ceramic coatings in electrolyte plasma on aluminium alloysSurface and Coatings Technology, 1998