Tracking Control of Ball Screw Drives Using ADRC and Equivalent-Error-Model-Based Feedforward Control
Authors:
- 13 July 2016
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 63 (12) , 7682-7692
Abstract
This paper proposes a novel disturbance-rejection tracking controller for ball screw feed drives. First, active-disturbance-rejection control (ADRC) and proportional-integral (PI) control are employed to ensure the performance of the closed-loop system. In this control framework, the extended state observer estimates and compensates for unmodeled dynamics, parameter perturbations, variable cutting load, and other uncertainties, which improves the disturbance-rejection performance and robustness of the system. Then, based on ADRC feedback linearization, a novel equivalent-error-model-based feedforward controller is designed to further improve the tracking performance of the system. This equivalent error model is independent of the mechanical model, simple to design and easy to tune. Simulations and experimental results demonstrate that the proposed control method has better tracking performance and robustness against the internal and external disturbances compared with the conventional P-PI controller.Keywords
Funding Information
- National Science and Technology Major Project of China (2015ZX04001002, 2015ZX04005001)
This publication has 25 references indexed in Scilit:
- Disturbance rejection control method for permanent magnet synchronous motor speed-regulation systemMechatronics, 2012
- Machine tool feed drivesCIRP Annals, 2011
- Minimum Tracking Error Control of Flexible Ball Screw Drives Using a Discrete-Time Sliding Mode ControllerJournal of Dynamic Systems, Measurement, and Control, 2009
- Calibration-free robotic eye-hand coordination based on an auto disturbance-rejection controllerIEEE Transactions on Robotics, 2004
- Gain-scheduling control of machine tools with varying structural flexibilityCIRP Annals, 2004
- Sliding Mode Controller Design for High Speed Feed DrivesCIRP Annals, 2000
- An Approach to Control Input Shaping With Application to Coordinate Measuring MachinesJournal of Dynamic Systems, Measurement, and Control, 1999
- A Comparison of Linear and Conventional Electromechanical DivesCIRP Annals, 1998
- Robust motion controller design for high-accuracy positioning systemsIEEE Transactions on Industrial Electronics, 1996
- Robust speed control of DC servomotors using modern two degrees-of-freedom controller designIEEE Transactions on Industrial Electronics, 1991