Selective Thin-Film Deposition for Optofluidic Platforms With Optimized Transmission
- 24 March 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Photonics Technology Letters
- Vol. 23 (11) , 721-723
Abstract
Selective deposition of dielectric thin films on an optofluidic biosensor provides the means for low loss in hollow-core waveguides and increased solid- to hollow-core coupling. Polymethylglutarimide (PMGI) is used over nonplanar topographies to provide liftoff patterning of dielectric films deposited at temperatures up to 250°C . This fabrication method provides throughput improvement in devices with hollow-cores longer than 2 mm.Keywords
This publication has 11 references indexed in Scilit:
- Slow light on a chip via atomic quantum state controlNature Photonics, 2010
- Optofluidic notch filter integration by lift-off of thin filmsOptics Express, 2010
- Ultrasensitive Qβ phage analysis using fluorescence correlation spectroscopy on an optofluidic chipBiosensors and Bioelectronics, 2009
- Improving solid to hollow core transmission for integrated ARROW waveguides.Optics Express, 2008
- Optofluidic waveguides: I. Concepts and implementationsMicrofluidics and Nanofluidics, 2007
- Optofluidic waveguides: II. Fabrication and structuresMicrofluidics and Nanofluidics, 2007
- On-chip surface-enhanced Raman scattering detection using integrated liquid-core waveguidesApplied Physics Letters, 2007
- Developing optofluidic technology through the fusion of microfluidics and opticsNature, 2006
- Integrated hollow and solid-core waveguides for sensor platforms2005
- A new sacrificial layer process for the fabrication of micromechanical systemsJournal of Micromechanics and Microengineering, 1997