Residual Stresses Due to Debris Effects in EHL Contacts
Authors:
- 1 January 1997
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 40 (4) , 613-620
Abstract
Debris in lubricated contacts significantly reduces the contact fatigue life. The life reduction is due to the surface damage caused by debris denting and the subsequent overrolling of the dent in the EHL contact. High pressure spikes are generated due to the dent which will modify the contact stress profiles, leading to stress concentration at or near the surface. In this paper, the residual stresses caused by debris effects are investigated. The residual stresses originate from the debris denting process and from the overrolling process of the dent in EHL contacts. The finite element method was used to investigate the residual stresses due to each process and their combined effects on the internal stress distribution of an EHL contact. It was found that the residual stress from debris denting will increase the internal stresses in an EHL contact. However, the residual stresses from overrolling of dent will reduce the internal stresses. The residual stresses are largely dependent on the plastic modulus of the contacting materials and need to be considered when investigating the internal stresses in heavily loaded lubricated contacts.Keywords
This publication has 17 references indexed in Scilit:
- Finite Element Analysis of Rolling Contact for Nonlinear Kinematic Hardening Bearing SteelJournal of Tribology, 1995
- An Analytical Approach to Elastic-Plastic Stress Analysis of Rolling ContactJournal of Tribology, 1994
- A Direct Analysis of Two-Dimensional Elastic-Plastic Rolling ContactJournal of Tribology, 1993
- Elasto-Plastic Finite Element Analysis of Three-Dimensional Pure Rolling Contact Above the Shakedown LimitJournal of Applied Mechanics, 1991
- Elastoplastic Finite Element Analysis of Three-Dimensional, Pure Rolling Contact at the Shakedown LimitJournal of Applied Mechanics, 1990
- The Effects of Particulate Contamination in Rolling Bearings—a State of the Art ReviewProceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering, 1990
- The Strength of Surfaces in Rolling ContactProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 1989
- Debris Damage in Rolling Bearings and Its Effects on Fatigue LifeJournal of Tribology, 1988
- The Influence of Certain Raceway Dent Geometries (3-D) on Contact Stresses and Rating Fatigue Life of Rolling BearingsJournal of Tribology, 1987
- An Elastic-Plastic Finite Element Model of Rolling Contact, Part 1: Analysis of Single ContactsJournal of Applied Mechanics, 1985