Effect of Contact Ratio on Spur Gear Dynamic Load With No Tooth Profile Modifications
Authors:
- 1 September 1996
- journal article
- Published by Wiley in Journal of Mechanical Design
- Vol. 118 (3) , 439-443
Abstract
This paper presents a computer simulation showing how the gear contact ratio affects the dynamic load on a spur gear transmission. The contact ratio can be affected by the tooth addendum, the pressure angle, the tooth size (diametral pitch), and the center distance. The analysis presented in this paper was performed by using the NASA gear dynamics code DANST. In the analysis, the contact ratio was varied over the range 1.20 to 2.40 by changing the length of the tooth addendum. In order to simplify the analysis, other parameters related to contact ratio were held constant. The contact ratio was found to have a significant influence on gear dynamics. Over a wide range of operating speeds, a contact ratio close to 2.0 minimized dynamic load. For low-contact-ratio gears (contact ratio less than two), increasing the contact ratio reduced gear dynamic load. For high-contact-ratio gears (contact ratio equal to or greater than 2.0), the selection of contact ratio should take into consideration the intended operating speeds. In general, high-contact-ratio gears minimized dynamic load better than low-contact-ratio gears.Keywords
This publication has 11 references indexed in Scilit:
- On Dynamic Loads in Parallel Shaft Transmissions: Part I—Modelling and AnalysisJournal of Mechanical Design, 1988
- Effects of Contact Ratio and Profile Correction on Gear Rotational VibrationBulletin of JSME, 1983
- ON THE EFFECT OF THE TOOTH PROFILE MODIFICATION ON THE DYNAMIC LOAD AND THE SOUND LEVEL OF THE SPUR GEARBulletin of JSME, 1982
- Compliance and Stress Sensitivity of Spur Gear TeethJournal of Mechanical Design, 1981
- An Extended Model for Determining Dynamic Loads in Spur GearingJournal of Mechanical Design, 1981
- Factors Influencing Instability and Resonances in Geared SystemsJournal of Mechanical Design, 1981
- Vibrational Excitation of Cylindrical Involute Gears Due to Tooth Form ErrorBulletin of JSME, 1980
- A Parametric Analysis of High-Contact-Ratio Spur GearsA S L E Transactions, 1976
- Dynamic Behavior of Heavy-Loaded Spur GearsJournal of Engineering for Industry, 1974
- Dynamic Loads on the Teeth of Spur GearsProceedings of the Institution of Mechanical Engineers, 1958