Structure and properties of nanocomposites prepared from ball milled 6061aluminium alloy with ZrO2 nanoparticles
- 7 October 2009
- journal article
- research article
- Published by Wiley in Crystal Research and Technology
- Vol. 44 (10) , 1163-1169
Abstract
Ball milling of 6061 aluminum alloy and nanocrystalline ZrO2 powder allowed to obtain homogeneous mixture of nanocrystalline aluminum solid solution of grain size near 50 nm and ZrO2 particles. The ZrO2 particles are partially transformed after milling from tetragonal to the monoclinic crystal structure. After hot pressing in vacuum at temperature of 380 °C bulk nanocomposites were obtained of porosity below 1% consisting of aluminum solid solution of the average grain size near 80 nm and nano‐size ZrO2 particles. Partial recrystallization occurred after hot pressing particularly near particles boundaries, where elongated recrystallized grains free from ZrO2 nanoparticles of thickness near 1 μm and length of a few μm were identified. Estimated fraction of recrystallized grains was below 10%. The compression strength approaching 1000 MPa was obtained in composites containing 20% ZrO2 nanoparticles, what is more than reported for ultra and nano‐grain 6XXX aluminum alloys.Keywords
This publication has 14 references indexed in Scilit:
- Residual stress and damage development in the aluminium alloy EN AW-6061 particle reinforced with Al2O3 under thermal fatigue loadingMaterials Science and Engineering: A, 2009
- Tensile deformation behavior of a sub-micrometer Al2O3/6061Al compositeMaterials Science and Engineering: A, 2008
- Damage mechanisms at room and high temperature in notched specimens of Al6061/Al2O3 particulate compositesComposites Science and Technology, 2008
- Dynamic shear band formation in Aluminum 6061-T6 and Aluminum 6061-T6/Al2O3 compositesMaterials Science and Engineering: A, 2007
- The structure and properties of PM composite materials based on EN AW-2124 aluminum alloy reinforced with the BN or Al2O3 ceramic particlesJournal of Materials Processing Technology, 2006
- Effect of sub-micron Al2O3 concentration on dry wear properties of 6061 aluminum based compositeJournal of Materials Processing Technology, 2006
- Abrasive wear of Al2O3 particle reinforced 2024 aluminium alloy composites fabricated by vortex methodComposites Part A: Applied Science and Manufacturing, 2006
- Tensile and fatigue properties of the AA6061/20vol% Al2O3p and AA7005/10vol% Al2O3p compositesComposites Science and Technology, 2006
- Sintering characteristic of Al2O3-reinforced 2xxx series Al composite powdersJournal of Alloys and Compounds, 2005
- Influence of Al2O3 reinforcement on the abrasive wear characteristic of Al2O3/PA1010 composite coatingsWear, 2005