Monte Carlo–calculated beam–quality and perturbation correction factors for helium–, carbon–, and neon–ion beams
Authors:
- 18 September 2025
- journal article
- Published by Wiley in Medical Physics
- Vol. 52 (10) , e70024
Abstract
Purpose: A new technique, multi‐ion radiotherapy, which uses He, O, and Ne ions in addition to C ions, has been proposed, though there is still limited information on the dosimetric quantities, such as the beam quality and perturbation correction factors, necessary to determine the absorbed dose‐to‐water for various ion species. In this study, beam‐quality correction factors, k Q , for He, C, and Ne ions in five types of ionization chambers were derived through Monte Carlo simulations. Additionally, perturbation effects attributed to the ionization chambers were analyzed in detail, and differences in these effects across chamber types and ions were clarified. Methods: The k Q values for 150 MeV/u‐He, 290 MeV/u‐C, and 400 MeV/u‐Ne ions were evaluated using the Geant4 Monte Carlo code. The f Q (the product of the water‐to‐air stopping power ratio and the perturbation correction factor) was obtained using the absorbed doses to water and to air inside the active volume of the ionization chamber. The k Q values were then calculated from the f Q and the literature‐extracted factors, and W air . To evaluate individual perturbation effects, each chamber component (such as the central electrode, wall, and stem in the modeled chambers) was replaced by water in turn, and the dose was recalculated for each modified geometry. From the ratio of these doses, the contribution of each component to the perturbation effect was estimated. Results: The derived k Q values were consistent with the code of practice for dosimetry, the revised TRS‐398, and varied slightly with the ion species, from He to Ne ions. Additionally, the k Q values increased by up to 1% compared with the current protocol values, particularly in plane‐parallel chambers. Analysis of contributions to the perturbation factors revealed that the perturbation effect due to the cavity, P cav , is significantly greater for light ions than for protons and had the most substantial impact among the evaluated individual perturbation factors. Conclusions: The revision of k Q values for light ions may result in the absorbed dose‐to‐water varying by up to 1% compared with doses calculated using the currently recommended k Q values. At the current stage, it has been confirmed that common k Q values can be applied to light ions from He to Ne in both Farmer and Markus type ionization chambers.Keywords
This publication has 37 references indexed in Scilit:
- Commissioning of Helium Ion Therapy and the First Patient Treatment With Active Beam DeliveryInternational Journal of Radiation Oncology - Biology - Physics (IJROBP), 2023
- On the perturbation effect and LET dependence of beam quality correction factors in carbon ion beamsMedical Physics, 2022
- Spot‐scanning hadron arc (SHArc) therapy: A proof of concept using single‐ and multi‐ion strategies with helium, carbon, oxygen, and neon ionsMedical Physics, 2022
- Monte Carlo calculation of perturbation correction factors for air-filled ionization chambers in clinical proton beams using TOPAS/GEANTZeitschrift für Medizinische Physik, 2021
- Monte Carlo simulated beam quality and perturbation correction factors for ionization chambers in monoenergetic proton beamsMedical Physics, 2020
- Validation of Geant4 fragmentation for Heavy Ion TherapyNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2017
- Configuration of the electron transport algorithm of PENELOPE to simulate ion chambersPhysics in Medicine & Biology, 2006
- Geant4—a simulation toolkitNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2003
- An empirical approach to the stopping power of solids and gases for ions from 3Li to 18Ar – Part IINuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2002
- An empirical approach to the stopping power of solids and gases for ions from 3Li to 18ArNuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms, 2001