PLA/Carbon Nanotubes Multifilament Yarns for Relative Humidity Textile Sensor
- 1 September 2011
- journal article
- research article
- Published by SAGE Publications in Journal of Engineered Fibers and Fabrics
- Vol. 6 (3)
Abstract
Polylactide (PLA) was mixed with 4 wt.% of carbon nanotubes (CNTs) to produce electrical conductive multifilament yarns by melt spinning process for humidity detection. Thanks to a variation of electrical conductivity, this flexible sensor could detect the moisture presence. The introduction of plasticizer was necessary to ensure higher fluidity and drawability of the blend during the spinning process. The plasticizer modifies the crystallinity and the mechanical properties of the yarns. The effectiveness of this sensor (PLA/4 wt.% CNTs fibres) sensitive to humidity, is optimal when the spinning conditions are adapted. In this way, the temperature and the rate of the drawing roll were reduced. The influence of these parameters on the crystallinity, the mechanical properties and the sensitivity of the yarns were studied. Once the appropriate spinning conditions found, one humidity sensitive yarn was processed and the repeatability and efficient reversibility of its sensitivity were highlighted.Keywords
This publication has 44 references indexed in Scilit:
- Flame retardancy of polylactide: an overviewPolymer Chemistry, 2010
- Study on the preparation and characterization of biodegradable polylactide/multi-walled carbon nanotubes nanocompositesPolymer, 2007
- (Plasticized) Polylactide/clay nanocomposite textile: thermal, mechanical, shrinkage and fire propertiesJournal of Materials Science, 2007
- Electrical properties of low-density polyethylene/multiwalled carbon nanotube nanocompositesMaterials Chemistry and Physics, 2006
- Low percolation threshold in single-walled carbon nanotube/high density polyethylene composites prepared by melt processing techniqueCarbon, 2006
- Polylactide/montmorillonite nanocomposites: study of the hydrolytic degradationPolymer Degradation and Stability, 2005
- Effect of the length and the aggregate size of MWNTs on the improvement efficiency of the mechanical and electrical properties of nanocomposites—experimental investigationComposites Part A: Applied Science and Manufacturing, 2003
- Determination of spherulite growth rates of poly(l-lactic acid) using combined isothermal and non-isothermal proceduresPolymer, 2001
- Properties and morphologies of poly(?-lactide): 1. Annealing condition effects on properties and morphologies of poly(?-lactide)Polymer, 1995
- Helical microtubules of graphitic carbonNature, 1991