Ba 0.6 Sr 0.4 TiO 3 – MgO Ceramic Powders with Uniform Microstructures Prepared by Aqueous Gelcasting‐Assisted Solid‐State Method
Authors:
- 2 March 2012
- journal article
- research article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 95 (6) , 1960-1964
Abstract
A novel forming method–aqueous gelcasting was used to assist conventional solid‐state method to prepare 45 wt% Ba 0.6 Sr 0.4 TiO 3 –55 wt% MgO ( BSTM ) ceramic powders. For comparison purpose, conventional solid‐state method was also used to synthesize the same powders. It is found that the BSTM ceramic powders prepared by our method are more uniform with smaller and more sphere‐like particles than those prepared by the conventional method, whereas the phase compositions are completely the same no matter what powder preparation method is adopted. In addition, the BSTM green samples and ceramics from powders prepared by our method are more uniform than those from powders prepared by the conventional method. Moreover, it is found that using this novel method to prepare BSTM ceramic powders could not only improve the dielectric properties of the BSTM ceramics, but also decrease their sintering temperature. Aqueous gelcasting–assisted solid‐state method could be a novel promising method to prepare high performance ceramic powders in the future.Keywords
This publication has 20 references indexed in Scilit:
- Dielectric and tunable characteristics of Ba0.4Sr0.6TiO3–BaWO4 composite ceramics for microwave applicationsMaterials Research Bulletin, 2011
- Fabrication of textured ferroelectric ceramics by magnetic alignment via gelcastingJournal of the European Ceramic Society, 2007
- Dielectric and tunable characteristics of barium strontium titanate modified with Al2O3 additionMaterials Science and Engineering: B, 2003
- Structural and dielectric properties of the system Ba1−xSrxFe0.01Ti0.99O3Materials Letters, 2003
- MgO-mixed Ba0.6Sr0.4TiO3 bulk ceramics and thin films for tunable microwave applicationsJournal of Applied Physics, 2002
- Do we really need ferroelectrics in paraelectric phase only in electrically controlled microwave devices?IEEE Transactions on Microwave Theory and Techniques, 2001
- Dielectric properties of bismuth doped Ba1−xSrxTiO3 ceramicsJournal of the European Ceramic Society, 2001
- Ferroelectric thin film and broadband satellite systemsIEEE Potentials, 2001
- Nonlinear behavior of thin film SrTiO3 capacitors at microwave frequenciesJournal of Applied Physics, 1998
- Near single crystal-level dielectric loss and nonlinearity in pulsed laser deposited SrTiO3 thin filmsApplied Physics Letters, 1998