Effect of via separation and low-k dielectric materials on the thermal characteristics of Cu interconnects
Authors:
- K. BanerjeeKBK. Banerjee
- K.C. SaraswatKSK.C. Saraswat
- 11 November 2002
- conference paper
- Published by Institute of Electrical and Electronics Engineers (IEEE)
- p. 261-264
Abstract
This paper reports the impact of vias on the spatial distribution of temperature rise in metal lines and shows that the temperature is highly dependent on the via separation. A 3D electro-thermal simulation methodology using a short-pulse stress is presented to evaluate interconnect design options from a thermal point of view. The simulation methodology has also been applied to quantify the use of dummy thermal vias as additional heat sinking paths to alleviate the temperature rise in the metal wires for the first time. Finally, the impact of metal wire aspect ratio and low-k dielectrics on interconnect thermal characteristics is discussed.Keywords
This publication has 8 references indexed in Scilit:
- Investigation of self-heating phenomenon in small geometry vias using scanning Joule expansion microscopy2003
- On thermal effects in deep sub-micron VLSI interconnects2003
- The effect of interconnect scaling and low-k dielectric on the thermal characteristics of the IC metal2002
- Reduction of wiring capacitance with new low dielectric SiOF interlayer film for high speed/low power sub-half micron CMOS2002
- A Cu/low-κ dual damascene interconnect for high performance and low cost integrated circuits2002
- Damascene integration of copper and ultra-low-k xerogel for high performance interconnects2002
- Quantitative projections of reliability and performance for low-k/Cu interconnect systems2002
- High-current failure model for VLSI interconnects under short-pulse stress conditionsIEEE Electron Device Letters, 1997