Calculation of the INEL Beryllium Multiplication Experiment
Authors:
- 1 May 1991
- journal article
- research article
- Published by Taylor & Francis in Fusion Technology
- Vol. 19 (3P2B) , 2007-2015
Abstract
A precise calculational analysis of the INEL manganese bath experiment to measure beryllium neutron multiplication has been performed. The goal throughout the analysis was the minimization of all sources of error due to the calculational model and method. An extremely detailed three-dimensional Monte Carlo geometry model was developed for use with the code MCNP. Calculations were performed for a bare-source and four beryllium sample configurations for both DT and 252Cf neutron sources. The primary objective of the analysis was the calculation of various neutron-economy parameters applied as experimental corrections, either directly or as verification of measured values. The most significant of these were the tank leakage, duct streaming, structural absorption, fractional bath capture in manganese, high-energy parasitic bath absorption, neutron multiplication in other materials, and indirect absorption and multiplication in beryllium.Keywords
This publication has 3 references indexed in Scilit:
- Reanalysis of Neutron Multiplication Measurements in Thick Beryllium and Graphite Assemblies for 14-MeV NeutronsFusion Technology, 1987
- Measurements and Calculations of the Leakage Multiplication from Hollow Beryllium SpheresFusion Technology, 1985
- Neutron Multiplication Studies in Beryllium for Fusion Reactor BlanketsNuclear Science and Engineering, 1979