Correlation between Supersaturation of Solid Solution and Mechanical Behaviour of Two Binary Al-Si-Alloys
- 20 June 2014
- journal article
- Published by Trans Tech Publications, Ltd. in Materials Science Forum
- Vol. 794-796, 508-514
Abstract
Cooling of age-hardening Al-alloys after solution annealing is a critical step with respect to distortion and residual stresses. In order to predict their extent by simulation models, the mechanical behaviour must be known in a wide range of conditions and compositions. Therefore, experimental data is needed both for calibration and validation of the mechanical model. It is known for Al-Mg-Si alloys that supersaturation of the solid solution leads to a significant increase of strength during cooling. In order to understand the influence of single alloying elements on the strengthening effect, the mechanical properties of different binary alloys are investigated experimentally. The precipitation behaviour during cooling was investigated by Differential Scanning Calorimetry in a wide cooling rate range. A methodology to determine the degree of supersaturation of the solid solution based on the calorimetric results is presented. This approach is compared to atom probe tomography data. The mechanical behaviour of the alloys after various heat treatments was analysed by mechanical tests performed in a quenching and deformation dilatometer. Flow curves with high resolution at small strains (< 3 %) were measured at different temperatures. The results of the different experimental techniques are discussed in comparison and with respect to their testing limitations.Keywords
This publication has 12 references indexed in Scilit:
- Development of continuous cooling precipitation diagrams for aluminium alloys AA7150 and AA7020Journal of Alloys and Compounds, 2014
- Modelling work hardening of aluminium alloys containing dispersoidsPhilosophical Magazine, 2013
- The effect of silicon on the strengthening and work hardening of aluminum at room temperatureMaterials Science and Engineering: A, 2013
- Mechanical properties of undercooled aluminium alloys and their implementation in quenching simulationMaterials Science and Technology, 2012
- Continuous cooling precipitation diagrams of Al–Mg–Si alloysMaterials Science and Engineering: A, 2012
- Recording of continuous cooling precipitation diagrams of aluminium alloysThermochimica Acta, 2009
- Similarities and differences in heat treatment simulation of aluminium alloys and steelsMaterialwissenschaft und Werkstofftechnik, 2009
- Modelling mechanical properties for non-hardenable aluminium alloysComputational Materials Science, 2007
- The Effect of Chemical Composition and Microstructure on the Flow Stress during Hot Deformation of Aluminium AlloysMaterials Science Forum, 2000
- The Al-Si (Aluminum-Silicon) systemBulletin of Alloy Phase Diagrams, 1984