Optimal Sensor Placement for Laminated Composite and Steel Cantilever Beams by the Effective Independence Method
- 10 February 2020
- journal article
- research article
- Published by Taylor & Francis in Structural Engineering International
- Vol. 31 (1) , 85-92
Abstract
In modal testing, the quality of vibration signals and clarity of peak points to extract the natural frequencies, corresponding mode shapes and damping ratio depend on the number and location of the sensors. High measurement costs are required for structural identification and long-term structural health monitoring in large structures, which require a high number of sensors. Therefore, the minimum number of sensors should be placed at appropriate locations on the system during experimental measurements to ensure both information of sufficient quality and cost reductions. The aim of this study is to perform cost-efficient non-destructive modal tests for a laminated composite and steel cantilever beams using an optimal sensor placement approach. Finite element models of the sample beams are constituted in ANSYS® software to determine the initial candidate set of sensor locations. Then, ambient vibration tests are conducted. Based on the experimental modal amplitudes and mode shapes, optimal sensor locations are determined using the effective independence method, and measurements are repeated. The study shows that there is good agreement between the natural frequencies and mode shapes obtained from the initial measurements and those obtained using the limited number of sensors.Keywords
This publication has 42 references indexed in Scilit:
- Sensor placement optimization for structural modal identification of flexible structures using genetic algorithmJournal of Mechanical Science and Technology, 2015
- Optimal Sensor Placement for Modal Identification of Bridge Systems Considering Number of Sensing NodesJournal of Bridge Engineering, 2014
- Optimal sensor placement in health monitoring of suspension bridgeScience China Technological Sciences, 2012
- Optimal sensor placement techniques for system identification and health monitoring of civil structuresSmart Structures and Systems, 2008
- The connection between effective independence and modal kinetic energy methods for sensor placementJournal of Sound and Vibration, 2007
- On the optimal sensor placement techniques for a bridge structureEngineering Structures, 2005
- Sensor set expansion for modal vibration testingMechanical Systems and Signal Processing, 2005
- SENSOR PLACEMENT GUIDE FOR STRUCTURAL JOINT STIFFNESS MODEL IMPROVEMENTMechanical Systems and Signal Processing, 1997
- Optimal transducer placement for health monitoring of long span bridgeSoil Dynamics and Earthquake Engineering, 1997
- Sensor placement for on-orbit modal identification and correlation of large space structuresJournal of Guidance, Control, and Dynamics, 1991