Mapping Subsurface Conditions and Detecting Seepage Channels for an Embankment Dam Using Geophysical Methods: A Case Study of the Kinion Lake Dam
Authors:
- 19 September 2019
- journal article
- research article
- Published by Environmental and Engineering Geophysical Society in Journal of Environmental and Engineering Geophysics
- Vol. 24 (3) , 373-386
Abstract
Capacitively-Coupled Resistivity (CCR), Electrical Resistivity Tomography (ERT), and seismic surface wave testing using Love and Rayleigh waves were performed on Kinion Lake Dam, an embankment dam that has historically experienced significant seepage and internal erosion issues. The goal of this study is to detect seepage locations in the embankment dam for remediation purposes and map bedrock location across the area using nondestructive geophysical measurements. Surveys were completed along the crest and downstream toe of the dam to map subsurface conditions with a focus on seepage detection. The seismic surface wave data were analyzed using two different methods: Multichannel Analysis of Surface Waves (MASW) and Full Waveform Inversion (FWI). Both MASW and FWI methods were shown to be capable of resolving the bedrock layer below the dam, but the FWI method, provided a higher resolution image of the subsurface conditions compared to MASW method. However, the MASW and FWI provided little guidance regarding the seepage path through the dam. The CCR and ERT surveys, on the other hand, were shown to be very valuable for seepage detection. The seepage paths of the embankment dam were detected by comparing the resistivity measurements acquired in a wet winter and a dry summer. These seepage regions correspond well with previous sinkholes observed in the pool area following a drought. Additionally, new drilling in the two regions which showed differences in resistivity indicated the areas contained highly fractured limestone with evidence of solution cavities. It seems that the highly fractured limestone becomes fully saturated during the wet season causing very low resistivity values for these layers in wet seasons, but it quickly loses the water during the dry season leading to a highly resistive material in dry seasons. Therefore, seasonal resistivity measurements can be considered as a useful method for locating potential weak zones of earthen hydraulic structures in a cost-effective and timely manner.Keywords
This publication has 22 references indexed in Scilit:
- Hydrogeophysical characterization and monitoring of the hyporheic and riparian zones: The Vermigliana Creek case studyScience of The Total Environment, 2019
- Combined geophysical surveys for the characterization of a reconstructed river embankmentEngineering Geology, 2016
- 2D characterization of near‐surface : surface‐wave dispersion inversion versus refraction tomographyNear Surface Geophysics, 2015
- Characterization of an earth-filled dam through the combined use of electrical resistivity tomography, P- and SH-wave seismic tomography and surface wave dataJournal of Applied Geophysics, 2014
- Capacitive resistivity inversion using effective dipole lengths for line antennasJournal of Applied Geophysics, 2013
- Surface Wave Benchmarking Exercise: Methodologies, Results, and Uncertainties2011
- Utilization of Integrated Geophysical Surveying for the Safety Assessment of Levee Systems2011
- Feasibility of the surface-wave method for the assessment of physical properties of a dam using numerical analysisJournal of Applied Geophysics, 2006
- The statistics of embankment dam failures and accidentsCanadian Geotechnical Journal, 2000
- Rapid least‐squares inversion of apparent resistivity pseudosections by a quasi‐Newton method1Geophysical Prospecting, 1996