Gas penetration through pneumatically driven PDMS micro valves
Authors:
- 23 August 2013
- journal article
- research article
- Published by Royal Society of Chemistry (RSC) in RSC Advances
- Vol. 3 (39) , 17968-17976
Abstract
Integration of valve like structures into microfluidic chips is a key factor for the usability of many microfluidic systems. One approach is utilization of thin PDMS layers as flexible membranes which can be closely packed on the microfluidic chips. These flexible membranes can be deformed by pneumatic actuation, closing or opening the fluidic channel of the corresponding valve. However, PDMS is permeable to gases and this permeability gets non-negligible for common valve layer thicknesses and pressure gradients. This factor restricts the usage of PDMS valves in microfluidic systems, as gas bubbles are strictly prohibited in many applications. Here two methods avoiding the intrusion of gas into the microfluidic channels are introduced and investigated. The first is based on an oil droplet placed in the dead end pneumatic channel of the valve, the second utilizes a parylene coating to make PDMS impermeable to gases. The parylene layer could not completely suppress the gas intrusion into the fluidics of the valve and additionally influenced the sealing capabilities of the valve. The oil droplet, in contrast, suppressed the permeability of the valve completely and provides a straight forward solution. In the experimental setup a novel valve design is introduced and characterized. Sealing capabilities, hydraulic resistance and lifetime are measured, dead and internal volume are calculated to describe the capabilities of thin membrane PDMS valves. These values are of interest if the valves are to be used industrially. The design introduced here is easy to fabricate and requires low alignment accuracy: it uses a Polycarbonate/PDMS sandwich, bonded by a APTES coating. Combining the simplicity of the valve design and the low cost fabrication methods and materials needed, the valve is perfectly suited as a disposable consumable.Keywords
This publication has 16 references indexed in Scilit:
- Characterization of postfabricated parylene C coatings inside PDMS microdevicesSensors and Actuators B: Chemical, 2011
- Simple room temperature bonding of thermoplastics and poly(dimethylsiloxane)Lab on a Chip, 2010
- PMMA/PDMS valves and pumps for disposable microfluidicsLab on a Chip, 2009
- Simple structured polydimethylsiloxane microvalve actuated by external air pressureProceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science, 2006
- Development and multiplexed control of latching pneumatic valves using microfluidic logical structuresLab on a Chip, 2006
- Development of a low cost hybrid Si/PDMS multi-layered pneumatic microvalveMicrosystem Technologies, 2005
- A pneumatically controllable flexible and polymeric microfluidic valve fabricated viain situdevelopmentJournal of Micromechanics and Microengineering, 2005
- A disposable, dead volume-free and leak-free in-plane PDMS microvalveSensors and Actuators A: Physical, 2004
- Microfluidic Large-Scale IntegrationScience, 2002
- Monolithic Microfabricated Valves and Pumps by Multilayer Soft LithographyScience, 2000