Shear band development in polycrystals
Authors:
- 8 December 1993
- journal article
- Published by The Royal Society in Proceedings of the Royal Society of London. Series A: Mathematical and Physical Sciences
- Vol. 443 (1919) , 547-562
Abstract
Shear band localizations are studied using a band model involving two polycrystalline aggregates; one representing the material inside the potential band and the other the material outside. Each of these aggregates is assumed to be homogeneously deformed and conditions of compatibility and equilibrium are enforced across the band interfaces. The aggregate constitutive response is obtained from a generalized Taylor polycrystal model, in which each grain is characterized in terms of an elastic–viscoplastic continuum slip constitutive relation, so that no ambiguity arises concerning the choice of active slip systems. Because of the material rate sensitivity a shear band bifurcation is ruled out at achievable strain levels, but localization occurs from the growth of an initial inhomogeneity. Results are presented for imposed loading histories of plane strain tension, biaxial tension and simple shear, both for an initially isotropic aggregate and for an aggregate that has undergone a pre-strain in plane strain compression. Depending on the material properties, the initial conditions and the imposed deformation state, either (i) localization, in the sense of a very high strain rate concentration in the band, takes place; or (ii) the band strain rate increases rapidly for a short interval and then saturates; or (iii) the initial inhomogeneity does not induce a large strain rate concentration in the band. The initial pre-strain promotes earlier localization in plane strain tension and in simple shear. In biaxial tension, localization occurs earlier for the pre-strained material if the initial imperfection is large, but tends to saturate for smaller imperfections. The effects of variations in imperfection amplitude and material strain rate sensitivity are illustrated.Keywords
This publication has 32 references indexed in Scilit:
- The finite deformation of rate-dependent polycrystals—II: A comparison of the self-consistent and Taylor methodsJournal of the Mechanics and Physics of Solids, 1991
- Constitutive modelling of orthotropic plasticity in sheet metalsJournal of the Mechanics and Physics of Solids, 1990
- Analysis of large-strain shear in rate-dependent face-centred cubic polycrystals: correlation of micro- and macromechanicsPhilosophical Transactions of the Royal Society of London. Series A, Mathematical and Physical Sciences, 1989
- Shear band bifurcations in ductile single crystalsJournal of the Mechanics and Physics of Solids, 1983
- Perspectives in the mechanics of elastoplastic crystalsJournal of the Mechanics and Physics of Solids, 1982
- Initiation of localized shear bands in plane strainJournal of the Mechanics and Physics of Solids, 1980
- A class of phenomenological corner theories of plasticityJournal of the Mechanics and Physics of Solids, 1979
- Elastic-plastic behaviour of polycrystalline metals and compositesProceedings of the Royal Society of London. A. Mathematical and Physical Sciences, 1970
- On the Structure of Stress-Strain Relations for Time-Dependent Plastic Deformation in MetalsJournal of Applied Mechanics, 1970
- A self-consistent mechanics of composite materialsJournal of the Mechanics and Physics of Solids, 1965