Analysis and implementation of a soft switching converter with high-voltage conversion ratio
Authors:
- 4 September 2008
- journal article
- Published by Institution of Engineering and Technology (IET) in IET Power Electronics
- Vol. 1 (3) , 386-394
Abstract
The zero voltage switching (ZVS) boost converter with high-voltage gain is presented to overcome the limit of conventional boost converter with narrow turn-off period. Compared with the conventional boost converter, the adopted converter has wide turn-off period so that the higher output voltage can be achieved. The boost type of active clamp is used to limit the voltage stress of power switch. The resonance based on the output capacitance of power switch and resonant inductance will make the power switches to turn on at ZVS. The circuit configuration, principle operation, system analysis and design consideration of the adopted converter are presented. Finally, experiments conducted on a laboratory prototype rated at 240 W are presented to verify the effectiveness of the adopted converter.Keywords
This publication has 15 references indexed in Scilit:
- Three-Port Bidirectional Converter for Hybrid Fuel Cell SystemsIEEE Transactions on Power Electronics, 2007
- High-efficiency DC/DC converter with high voltage gainIEE Proceedings - Electric Power Applications, 2005
- Sensitivity Analysis of the Modeling Parameters Used in Simulation of Proton Exchange Membrane Fuel CellsIEEE Transactions on Energy Conversion, 2005
- A New ZVS Bidirectional DC–DC Converter for Fuel Cell and Battery ApplicationIEEE Transactions on Power Electronics, 2004
- Isolated DC-DC converters with high-output voltage for TWTA telecommunication satellite applicationsIEEE Transactions on Power Electronics, 2003
- Impedance specifications for stable DC distributed power systemsIEEE Transactions on Power Electronics, 2002
- Low-cost high power-density electronic ballast for automotive HID lampIEEE Transactions on Power Electronics, 2000
- The coupled inductor filter: analysis and design for AC systemsIEEE Transactions on Industrial Electronics, 1998
- Re-lift circuit: A new DC-DC step-up (BOOST) converterElectronics Letters, 1997
- A method of defining the load impedance specification for a stable distributed power systemIEEE Transactions on Power Electronics, 1995