Reduction of the Induced Voltage in the Synchronous Generator Shaft Using Active AC / DC Converter
Open Access
- 18 September 2020
- journal article
- research article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Access
- Vol. 8, 172318-172328
Abstract
Today, synchronous generators are broadly employed in the industry. The thyristor rectifier in the static excitation system of synchronous generators is responsible for supplying the DC voltage of the excitation winding. In these rectifiers, a high-frequency component is generated at the output of the DC voltage, during turning on and off of the thyristor. These high-frequency components charge the generator’s parasitic capacitors. The voltage induced in these capacitors induces the voltage in the synchronous generator shaft. In this paper, the induced voltage analysis in the generator shaft is performed. Then, modeling, simulation, and experimental laboratory results of pulse width modulation are performed in the static generator excitation system. The induced voltage of the generator shaft is examined by applying this rectifier and it is compared and analyzed with the results of the thyristor rectifier. The hiring of a pulse width modulation rectifier has had a great impact on reducing the induced shaft voltage.Keywords
Funding Information
- University of Aalborg
This publication has 22 references indexed in Scilit:
- Modelling and Simulation of Static Excitation System in Synchronous Machine Operation and Investigation of Shaft VoltageAdvances in Electrical Engineering, 2014
- A survey of shaft voltage reduction strategies for induction generators in wind energy applicationsRenewable Energy, 2013
- Practical approach to model electric motors for electromagnetic interference and shaft voltage analysisIET Electric Power Applications, 2010
- A Passive EMI Filter for Eliminating Both Bearing Current and Ground Leakage Current from an Inverter-Driven Motor2006
- Mitigation of the Adverse Effects of PWM Inverter Through Passive Cancellation Method2006
- Mitigation of Bearing Electro-Erosion of Inverter-Fed Motors Through Passive Common-Mode Voltage SuppressionIEEE Transactions on Industry Applications, 2005
- Motor shaft voltages and bearing currents and their reduction in multilevel medium-voltage PWM voltage-source-inverter drive applicationsIEEE Transactions on Industry Applications, 2000
- Modeling and analysis of static and dynamic characteristics for buck-type three-phase PWM rectifier by circuit DQ transformationIEEE Transactions on Power Electronics, 1998
- System electrical parameters and their effects on bearing currentsIEEE Transactions on Industry Applications, 1997
- Shaft voltages in generators with static excitation systems-problems and solutionIEEE Transactions on Energy Conversion, 1988