Microstructure Evolution and Tempering Transformation Kinetics in a Secondary Hardened M50 Steel Subjected to Cold Ring Rolling
Open Access
- 15 January 2021
- journal article
- research article
- Published by Iron and Steel Institute of Japan in ISIJ International
- Vol. 61 (1) , 361-371
Abstract
The microstructure evolution and tempering transformation kinetics of the M50 steel subjected to cold ring rolling (CRR) have been investigated. The results indicate that the brass R{110} texture is weakened with the enhancement of the //ND texture during CRR. Due to the increased low angle boundaries by CRR, the Ac1 temperature decreases while the carbon content and volume fraction of RA increase. During tempering, the activation energy of carbon atoms segregation and transition carbide precipitation decrease, while the activation energy of retained austenite (RA) decomposition increases after CRR. The kinetic analysis shows that the CRR is beneficial to the carbon atoms segregation during the beginning of tempering. Then, the CRR leads to the delay of the onset of transition carbide precipitation, but decreases the whole reaction time, which has been verified by the transmission electron microscopy (TEM) and hardness results. The lagging of transition carbide precipitation in the early stage is caused by the increased segregation trapping of carbon atoms, while the higher nucleation rate is responsible for the enhanced precipitation of transition carbide during the later stage. For the cementite formation, there are no significant changes in the predictive kinetics after the applied CRR. However, the kinetic transformation of RA decomposition is inhibited by the CRR, which is attributed to the higher carbon content and smaller grain size of RA. Additionally, the alloy carbides precipitation is also enhanced by the CRR process during secondary hardening.Keywords
This publication has 46 references indexed in Scilit:
- Time-dependent synchrotron X-ray diffraction on the austenite decomposition kinetics in SAE 52100 bearing steel at elevated temperatures under tensile stressActa Materialia, 2013
- Steels for bearingsProgress in Materials Science, 2012
- ICTAC Kinetics Committee recommendations for performing kinetic computations on thermal analysis dataThermochimica Acta, 2011
- Transformation from continuous-to-isothermal aging applied on a maraging steelMaterials Science and Engineering: A, 2010
- The effect of cold ring rolling on the evolution of microstructure and texture in 100Cr6 steelMaterials Science and Engineering: A, 2010
- Thermal stability of austenite retained in bainitic steelsMaterials Science and Engineering: A, 2010
- Formation of shear bands and strain-induced martensite during plastic deformation of metastable austenitic stainless steelsActa Materialia, 2007
- Subdivision of original grains during cold-rolling of interstitial-free steelScripta Materialia, 2004
- Effect of isothermal transformation temperature on amount of retained austenite and its thermal stability in a bainitic Fe–3%Si–0.45%C–X steelScripta Materialia, 2002
- Analysis of the kinetics of phase transformationsJournal of Materials Science, 1992