A dynamic melting model for a single‐screw extruder
Author:
- 1 April 1976
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 16 (4) , 284-291
Abstract
A new theoretical concept is given which provides an efficient and consistent method for predicting flow and heat transfer characteristics of the melting zone for a large single‐screw extruder. In contradistinction to previous, theories, significant melt accumulation in the molten films as observed experimentally is considered, instead of postulating the melt accumulation in the “melt pool”. The mathematical model has been obtained by the simultaneous solution of the momentum and energy equation of the melt flow and. solid bed, allowing for the existence of the pressure gradient: The theory is supplemented by a numerical example which shows good agreement with experimental data obtained on a 90 mm extruder with polypropylene, where the down‐channel pressure profile and me profile of the solid bed Were taken as yardsticks for the melting process. For exact determination of the area for applicability of this theory, more experimental information is required.Keywords
This publication has 6 references indexed in Scilit:
- Melting of thermoplastics in single screw extrudersPolymer, 1975
- Solids conveying in screw extruders part III: The delay zonePolymer Engineering & Science, 1972
- The melting of a crystalline polymer in a screw extruderChemical Engineering Science, 1971
- A theoretical melting model for plasticating extrudersPolymer Engineering & Science, 1971
- Melting in plasticating extuders theory and experimentsPolymer Engineering & Science, 1967
- Fundamentals of plasticating extrusion. I. A theoretical model for meltingPolymer Engineering & Science, 1966