Application of response surface methodology for modeling and optimization of trichloroacetic acid and turbidity removal using potassium ferrate(VI)
Open Access
- 17 February 2016
- journal article
- research article
- Published by Elsevier in Desalination and Water Treatment
- Vol. 57 (52) , 25317-25328
Abstract
Coagulation/flocculation and oxidation are two of the main processes in treating colloidal and organic substances. Potassium ferrate(VI), a multipurpose chemical, is used in water treatment plants as coagulant and oxidant. In this study, ferrate(VI) was evaluated for the degradation of trichloroacetic acid and turbidity removal in synthetic water. The effects of five independent variables, initial pH of solution (3–9), ferrate(VI) dosage (1–10 mg L−1), contact time (5–60 min), trichloroacetic acid concentration (100–1,000 μg L−1), and initial turbidity (1–10 NTU) were investigated and the process was optimized by means of response surface methodology. Trichloroacetic acid and turbidity removal efficiencies were considered as the process responses. The highest efficiency achieved for trichloroacetic acid removal was 24%, while for turbidity the maximum removal efficiency was in the range 85–95%. The optimum conditions for initial turbidity, pH, and ferrate dosage were 8.89 NTU, 3, and 4.26 mg L−1 as Fe, respectively. Experimentally obtained 89% turbidity removal in the optimum condition confirmed the results predicted by the model. Therefore, it can be concluded that ferrate(VI) can be effectively used in colloidal substances removal, while it is not successful enough in trichloroacetic acid decomposition.Keywords
This publication has 42 references indexed in Scilit:
- Optimizing the coagulation process in a drinking water treatment plant – comparison between traditional and statistical experimental design jar testsWater Science & Technology, 2012
- Optimization of the coagulation-flocculation process for pulp mill wastewater treatment using a combination of uniform design and response surface methodologyWater Research, 2011
- Coagulation characteristics of titanium (Ti) salt coagulant compared with aluminum (Al) and iron (Fe) saltsJournal of Hazardous Materials, 2011
- Effect of pH on the coagulation performance of Al-based coagulants and residual aluminum speciation during the treatment of humic acid–kaolin synthetic waterJournal of Hazardous Materials, 2010
- Decomposition of two haloacetic acids in water using UV radiation, ozone and advanced oxidation processesJournal of Hazardous Materials, 2009
- Aluminum Forms in Drinking Water and Risk of Alzheimer's DiseaseEnvironmental Research, 2000
- Unexpected selectivity in the oxidation of arylamines with ferrate–preliminary mechanistic considerationsChemical Communications, 1996
- Coagulation of low turbidity surface waters withMoringa oleiferaseedsInternational Journal of Environmental Studies, 1995
- Flocculation and sedimentation of high-turbidity watersWater Research, 1991
- Studies of hypervalent iron in aqueous solutions. 1. Radiation-induced reduction of iron(VI) to iron(V) by CO2-Journal of the American Chemical Society, 1987