Current programmed control of a single-phase two-switch buck-boost power factor correction circuit
Authors:
- 6 February 2006
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Industrial Electronics
- Vol. 53 (1) , 263-271
Abstract
This paper presents a new current programmed control (CPC) technique for a cascaded two-switch buck-boost converter suitable as a low-cost power factor correction (PFC) rectifier in a variable speed motor drive. This new CPC technique, which is an extension of the conventional CPC method, enables the variable output dc voltage, and is therefore suitable in a pulse amplitude modulated (PAM) motor drive or as a universal input-power supply. The CPC method is very simple and requires only a constant-current reference without any changes in the transition between boost and buck operating mode, and the line current is practically unaffected by the topology-mode shift. Simulations and experimental results verify the presented control technique. Compliance with IEC-61000-3-2 class A is achieved. The experimental setup is based on a commercial CPC integrated circuit (IC) for dc-dc converters. This new control technique enables a simple low-cost control circuit for the two-switch buck-boost converter, which complies with IEC-61000-3-2, and the PFC circuit has inherent in-rush and overcurrent protection.Keywords
This publication has 13 references indexed in Scilit:
- Previously unobserved effects of delay on current-mode control2003
- A new single phase buck-boost converter with unity power factor2002
- Analysis and design of constant-frequency peak-current-controlled high-power-factor boost rectifier with slope compensation2002
- Time-varying effects in models for current-mode control2002
- Sampled-data modeling of the average-input current-mode-controlled buck converterIEEE Transactions on Power Electronics, 1999
- A general technique for derivation of average current mode control laws for single-phase power-factor-correction circuits without input voltage sensingIEEE Transactions on Power Electronics, 1999
- Bang-bang current control with predecided switching frequency for switch-mode rectifiersIEEE Transactions on Industrial Electronics, 1999
- Nonlinear-carrier control for high-power-factor boost rectifiersIEEE Transactions on Power Electronics, 1996
- Design of the clamped-current high-power-factor boost rectifierIEEE Transactions on Industry Applications, 1995
- Modeling current-programmed buck and boost regulatorsIEEE Transactions on Power Electronics, 1989