Impact of silicide layer on single photon avalanche diodes in a 130 nm CMOS process
- 28 July 2016
- journal article
- research article
- Published by IOP Publishing in Journal of Physics D: Applied Physics
- Vol. 49 (34) , 345105
Abstract
Single photon avalanche diode (SPAD) is an attractive solid-state optical detector that offers ultra-high photon sensitivity (down to the single photon level), high speed (sub-nanosecond dead time) and good timing performance (less than 100 ps). In this work, the impact of the silicide layer on SPAD's characteristics, including the breakdown voltage, dark count rate (DCR), after-pulsing probability and photon detection efficiency (PDE) is investigated. For this purpose, two sets of SPAD structures in a standard 130 nm complementary metal oxide semiconductor (CMOS) process are designed, fabricated, measured and compared. A factor of 4.5 (minimum) in DCR reduction, and 5 in PDE improvements are observed when the silicide layer is removed from the SPAD structure. However, the after-pulsing probability of the SPAD without silicide layer is two times higher than its counterpart with silicide. The reasons for these changes will be discussed.Keywords
Funding Information
- NSERC of Canada
- NCE IC-IMPACTS
- Federal Economic Development Agency for Southern Ontario
- NSERC ResEau SN
- CFI
- Canada Research Chair Program
This publication has 51 references indexed in Scilit:
- Accounting for Interference, Scattering, and Electrode Absorption to Make Accurate Internal Quantum Efficiency Measurements in Organic and Other Thin Solar CellsAdvanced Materials, 2010
- Fully Integrated Single Photon Avalanche Diode Detector in Standard CMOS 0.18- $\mu$m TechnologyIEEE Transactions on Electron Devices, 2008
- Afterpulse timing and rate investigation of three different Hamamatsu Photomultiplier TubesJournal of Instrumentation, 2008
- Electronics for single photon avalanche diode arraysSensors and Actuators A: Physical, 2007
- Principles and features of single-photon avalanche diode arraysSensors and Actuators A: Physical, 2007
- First-principles study on electronic structure of Si/SiO2interface—Effect of interface defects on local charge densityScience and Technology of Advanced Materials, 2007
- Capture cross sections of defect states at the Si/SiO2 interfaceJournal of Applied Physics, 2000
- Characterization of shallow silicided junctions for sub-quarter micron ULSI technology. Extraction of silicidation induced Schottky contact areaIEEE Transactions on Electron Devices, 2000
- A new leakage mechanism of Co salicide and optimized process conditions [for CMOS]IEEE Transactions on Electron Devices, 1999
- On the modelling of tunnelling currents in reverse-biased p-n junctionsSolid-State Electronics, 1989