A Study of STS 316L Threaded Elbow Fitting Fabrication by Metal Injection Molding
Authors:
- J. Y. KimJKJ. Y. Kim
- S. J. KimSKS. J. Kim
- S. T. ChungSCS. T. Chung
- S. AhnSAS. Ahn
- 1 April 2015
- journal article
- Published by The Korean Society of Technology of Plasticity in Transactions of Materials Processing
- Vol. 24 (2) , 121-129
Abstract
No abstract availableKeywords
This publication has 12 references indexed in Scilit:
- Powder injection molding process design for UAV engine components using nanoscale silicon nitride powdersCeramics International, 2014
- Effects of process parameters in plastic, metal, and ceramic injection molding processesKorea-Australia Rheology Journal, 2011
- Powder-binder separation in injection moulded green partsJournal of the European Ceramic Society, 2010
- Effect of powders and binders on material properties and molding parameters in iron and stainless steel powder injection molding processPowder Technology, 2009
- Process simulation of powder injection moulding: identification of significant parameters during mould filling phasePowder Metallurgy, 2007
- Application of Taguchi optimization technique in determining plastic injection molding process parameters for a thin-shell partMaterials & Design (1980-2015), 2007
- The PVT effect on the final sintered dimensions of powder injection molded componentsMaterials & Design (1980-2015), 2007
- Development of niobium powder injection molding: Part I. Feedstock and injection moldingInternational Journal of Refractory Metals and Hard Materials, 2006
- Comparison of the warpage optimization in the plastic injection molding using ANOVA, neural network model and genetic algorithmJournal of Materials Processing Technology, 2006
- Metal injection molding: 3D modeling of nonisothermal fillingPolymer Engineering & Science, 2002