Adiabatically-tapered fiber mode multiplexers
Open Access
- 6 January 2014
- journal article
- research article
- Published by Optica Publishing Group in Optics Express
- Vol. 22 (1) , 608-617
Abstract
Simple all-fiber three-mode multiplexers were made by adiabatically merging three dissimilar single-mode cores into one multimode core. This was achieved by collapsing air holes in a photonic crystal fiber and (in a separate device) by fusing and tapering separate telecom fibers in a fluorine-doped silica capillary. In each case the LP01 mode and both LP11 modes were individually excited from three separate input cores, with losses below 0.3 and 0.7 dB respectively and mode purities exceeding 10 dB. Scaling to more modes is challenging, but would be assisted by using single-mode fibers with a smaller ratio of cladding to core diameter.Keywords
This publication has 15 references indexed in Scilit:
- Geometric requirements for photonic lanterns in space division multiplexingOptics Express, 2012
- “Photonic lantern” spectral filters in multi-core fibreOptics Express, 2012
- All-fiber LP_11 mode convertorsOptics Letters, 2008
- Wavelength-independent all-fiber mode convertersOptics Letters, 2007
- Ultrafast-laser inscription of a three dimensional fan-out device for multicore fiber coupling applicationsOptics Express, 2007
- 2 × 2 Single-mode fiber routing switchOptics Letters, 1996
- Performance tuning of 1×7 wavelength-flattened fused fibre couplersElectronics Letters, 1990
- Mode field diameter measurements in single-mode optical fibersJournal of Lightwave Technology, 1989
- Multichannel waveguide junctions for guided-wave opticsApplied Physics Letters, 1987
- Wavelength-flattened fused couplersElectronics Letters, 1985