Improving the UAS-S4 Éhecal airfoil high angles-of-attack performance characteristics using a morphing wing approach
Open Access
- 26 May 2015
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part G: Journal of Aerospace Engineering
- Vol. 230 (1) , 118-131
Abstract
In this paper, a morphing wing approach with a new methodology and its results for the high angles-of-attack optimization of the S4 unmanned aerial system airfoil are described. The boundary layer separation delay, coupled with an increase of the maximum lift coefficient, was achieved using an in-house optimization tool based on the artificial bee colony algorithm, coupled with the Broyden–Fletcher–Goldfarb–Shanno algorithm to provide a final refinement. The obtained results were validated with an advanced, multi-objective, commercially available optimizing tool. The aerodynamic calculations were performed using a two-dimensional linear panel method, coupled with an incompressible boundary layer model and a transition estimation criterion. For very small displacements of the airfoil surface, of less than 2.5 mm, lift coefficient increases of up to 18% together with relevant drag reductions have been achieved, successfully delaying separation for the high angles-of-attack range.Keywords
This publication has 42 references indexed in Scilit:
- A modified Artificial Bee Colony algorithm for real-parameter optimizationInformation Sciences, 2012
- Airfoil Structural Morphing Based on S.M.A. Actuator Series: Numerical and Experimental StudiesJournal of Intelligent Material Systems and Structures, 2011
- Aero-structural Design Optimization of a Morphing WingtipJournal of Intelligent Material Systems and Structures, 2011
- Design and Functional Test of a Morphing High-Lift Device for a Regional AircraftJournal of Intelligent Material Systems and Structures, 2011
- Aero-Structural Optimization and Performance Evaluation of a Morphing Wing with Variable Span and CamberJournal of Intelligent Material Systems and Structures, 2011
- Development of High-rate, Adaptive Trailing Edge Control Surface for the Smart Wing Phase 2 Wind Tunnel ModelJournal of Intelligent Material Systems and Structures, 2004
- The control of flow separation by periodic excitationProgress in Aerospace Sciences, 2000
- Study of Adaptive Shape Airfoils at Low Reynolds Number in Oscillatory FlowsAIAA Journal, 1997
- Aspects of turbulent boundary-layer separationProgress in Aerospace Sciences, 1996
- Vibration reduction in rotorcraft using active control - A comparison of various approachesJournal of Guidance, Control, and Dynamics, 1995