Strengthening face centered cubic crystals by annealing induced nano-twins
Open Access
- 13 December 2017
- journal article
- research article
- Published by Springer Nature in Scientific Reports
- Vol. 7 (1) , 17512
Abstract
Usually, cold working strengthen metals and alloys by introducing large population of dislocations, whereas annealing of cold worked metal recovers the structure, annihilates dislocations, forms new strain-free grains, and results loss of strength. Here, we report annealing-hardening at temperature well below stress relieving and recrystallization temperatures in contrast to the typical behavior. A large amount of structural defects, such as dislocations, grain boundaries, twins, and stacking faults, have been introduced in nanostructured α-brass by cryorolling. The interaction and rearrangement of these defects upon annealing at 165–200 °C have been monitored at an interval of 1 minute. Large increase of the yield strength up to 578 MPa has been achieved in annealed specimens, which is 23% higher than that of as-cryorolled, and 425% higher than that of as-cast brass due to the evolution of nano-twins. Our approach shows a new avenue on strengthening fcc crystals by incorporating annealing induced nano-twins.Keywords
This publication has 32 references indexed in Scilit:
- Evolution of nanostructure in α-brass upon cryorollingMaterials Science and Engineering: A, 2011
- Strengthening Materials by Engineering Coherent Internal Boundaries at the NanoscaleScience, 2009
- Mechanical properties and rolling behaviors of nano-grained copper with embedded nano-twin bundlesActa Materialia, 2008
- Evolution of defect structures during cold rolling of ultrafine-grained Cu and Cu–Zn alloys: Influence of stacking fault energyMaterials Science and Engineering: A, 2008
- Microstructural evolution and nanostructure formation in copper during dynamic plastic deformation at cryogenic temperaturesActa Materialia, 2008
- Enhanced hardening in Cu/330 stainless steel multilayers by nanoscale twinningActa Materialia, 2004
- A Maximum in the Strength of Nanocrystalline CopperScience, 2003
- Modelling of TWIP effect on work-hardeningMaterials Science and Engineering: A, 2001
- A profile-fitting procedure for analysis of broadened X-ray diffraction peaks. I. MethodologyJournal of Applied Crystallography, 1988
- Relationship between extrinsic stacking faults and mechanical twinning in F.C.C. solid solutions with low stacking fault energyJournal de Physique, 1984