A Piezoelectric Heterostructure Scavenging Mechanical Energy from Human Foot Strikes
Author:
Open Access
- 20 August 2022
- journal article
- research article
- Published by MDPI AG in Micromachines
- Vol. 13 (8) , 1353
Abstract
This paper presents a piezoelectric heterostructure for extracting mechanical energy from human foot strikes based on the impact of a moving block on the tips of the piezoelectric unimorph cantilevers. The use of the magnetic springs allows low-frequency and high-amplitude movements of the device. The piezoelectric unimorph cantilevers deform under a human foot strike on the pedal, and the piezoelectric elements in d31-mode produce output voltages. An analysis was conducted, and the working principle was stated. A prototype was fabricated to validate the feasibility of the proposed design. The experimental results show that the generated RMS voltage increases with human walking (running) speed. At the walking speed of 6 km/h, an average power of 36.26 μW is produced across a matching resistive load of 4 MΩ with an initial separating distance of 9 mm. Improvements of the device are possible, allowing an increase in the average power by increasing the number of piezoelectric unimorph cantilevers and using the piezoelectric materials with higher piezoelectric constants.Keywords
Funding Information
- National Natural Science Foundation of China (61761001)
This publication has 29 references indexed in Scilit:
- Energy harvesting from stray power-frequency magnetic field employing a piezoelectric unimorph based heterostructureThe European Physical Journal Applied Physics, 2016
- Design and experiment of a human-limb driven, frequency up-converted electromagnetic energy harvesterEnergy Conversion and Management, 2015
- Increased piezoelectric energy harvesting from human footstep motion by using an amplification mechanismApplied Physics Letters, 2014
- A Shoe-Embedded Piezoelectric Energy Harvester for Wearable SensorsSensors, 2014
- A piezoelectric frequency up-converting energy harvester with rotating proof mass for human body applicationsSensors and Actuators A: Physical, 2014
- Triboelectric nanogenerator built inside shoe insole for harvesting walking energyNano Energy, 2013
- Thermoelectric energy harvester on the heated human machineJournal of Micromechanics and Microengineering, 2011
- Plucked piezoelectric bimorphs for knee-joint energy harvesting: modelling and experimental validationSmart Materials and Structures, 2011
- Piezoelectric energy harvesting using shear mode 0.71Pb(Mg1/3Nb2/3)O3–0.29PbTiO3 single crystal cantileverApplied Physics Letters, 2010
- Induced voltage of piezoelectric unimorph cantilevers of different nonpiezoelectric/piezoelectric length ratiosSmart Materials and Structures, 2009