Scalar Diffusion Equation-Based Model to Predict 2-Dimensional Film Cooling Effectiveness of a Shaped Hole
- 22 March 2021
- journal article
- research article
- Published by Wiley in Journal of Turbomachinery
- Vol. 143 (4)
Abstract
One-dimensional laterally averaged adiabatic film cooling effectiveness η¯lat-based correlations have been widely employed in the cooling design of the modern gas turbine and aero-engine; however, the flow field of the discrete film cooling is fully three dimensional, and thus, the cooling effectiveness distribution on the solid surface is two dimensional. Accurate prediction of the cooling effectiveness distribution in the lateral direction would help to optimize the film cooling design, but few paid attention to this issue in the literature. In this study, a simple yet accurate scalar diffusion equation based model is proposed to extend the one-dimensional correlation into two dimensional. The model is proved to be accurate and efficient. According to the accuracy analysis, the R2 value is larger than 0.95 for the two-dimensional prediction and over 0.93 along the centerline. With given input parameters, the calculation cost for solving a certain case is in the magnitude of 1 × 10−3s in time using the space-marching method. There is only the effective diffusion coefficient left to be modeled in the control equation. It represents the balance between the diffusion and the passive transportation by the main flow. Analyses conducted within the typical experimental range show that κ~eff is only dependent on the velocity ratio and the main-flow turbulence.Keywords
Funding Information
- National Natural Science Foundation of China (51876098)
- National Science and Technology Major Project (2017-III-0009-0035)
This publication has 26 references indexed in Scilit:
- Film cooling sensitivity of laidback fanshape holes to variations in exit configuration and mainstream turbulence intensityInternational Journal of Heat and Mass Transfer, 2015
- Adiabatic Effectiveness Measurements for a Baseline Shaped Film Cooling Hole2014
- Calculation of 3-D Temperature Distribution in Film-Cooled Flat Plates Using 2-D Empirical Correlations for Film-Cooling Effectiveness and Heat Transfer Augmentation2012
- A Film-Cooling Correlation for Shaped Holes on a Flat-Plate SurfaceJournal of Turbomachinery, 2010
- Film-Cooling Effectiveness on a Rotating Blade PlatformJournal of Turbomachinery, 2008
- Gas Turbine Film CoolingJournal of Propulsion and Power, 2006
- Heat Flux Reduction From Film Cooling and Correlation of Heat Transfer Coefficients From Thermographic Measurements at Enginelike ConditionsJournal of Turbomachinery, 2002
- Correlation of Film-Cooling Effectiveness From Thermographic Measurements at Enginelike ConditionsJournal of Turbomachinery, 2002
- Effects of density and velocity ratio on discrete hole film coolingAIAA Journal, 1975
- Effects of hole geometry and density on three-dimensional film coolingInternational Journal of Heat and Mass Transfer, 1974