Finite Element Modeling and Analysis of Warm Forming of Aluminum Alloys—Validation Through Comparisons With Experiments and Determination of a Failure Criterion
Authors:
- 19 September 2005
- journal article
- Published by ASME International in Journal of Manufacturing Science and Engineering
- Vol. 128 (3) , 613-621
Abstract
In this study, thermomechanically coupled finite element analysis (FEA) was performed for forming aluminum rectangular cups at elevated temperatures. In order to identify the onset of a failure during FEA, applicability, accuracy, and repeatability of three different failure criteria (maximum load, minimum thickness, and thickness ratio) were investigated. The thickness ratio criterion was selected since it resulted in accurate prediction of necking-type failure when compared with experimental measurements obtained under a variety of warm forming conditions. Predicted part depth values from FEA at various die-punch temperature combinations and blank holder pressures conditions were also compared with experiments, and showed good agreement. Forming limit diagrams were established at three different warm forming temperature levels (, , and ). An increasing limiting strain was observed with increasing forming temperature both in FEA and experiments. In addition, strain distributions on the formed part obtained under different die-punch temperature combinations were also compared to further validate the accuracy of FEA. A high temperature gradient between die and punch was found to result in increased formability; i.e., high part depths.
Keywords
This publication has 13 references indexed in Scilit:
- Biaxial warm forming behavior of aluminum sheet alloysJournal of Materials Processing Technology, 2004
- Tensile deformation behavior of aluminum alloys at warm forming temperaturesMaterials Science and Engineering: A, 2003
- Finite element simulation of warm deep drawing of aluminium alloy sheet when accounting for heat conductionJournal of Materials Processing Technology, 2002
- Feasibility of warm drawing of aluminium productsJournal of Materials Processing Technology, 2001
- Sheet metal forming of magnesium wrought alloys — formability and process technologyJournal of Materials Processing Technology, 2001
- Tool temperature control to increase the deep drawability of aluminum 1050 sheetInternational Journal of Machine Tools and Manufacture, 2001
- Planning for an environment-friendly carTechnovation, 2000
- Effect of Forming Temperature on Deep Drawability of Aluminum Alloy Sheets1987
- Alloying aluminum with magnesium for ductility at warm temperatures (25 to 250°C)Metallurgical Transactions A, 1979
- Warm forming of aluminium/magnesium alloy sheetJournal of Materials Processing Technology, 1978